Yesterday's Tractor Co. Parts for Farm Tractors - Compare our Prices!
Click Here or call 800-853-2651 
   Allis Chalmers Case Farmall IH Ford 9N,2N,8N Ford
   Ferguson John Deere Massey Ferguson Minn. Moline Oliver
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   Traditional YT Forum ViewClassic View   RegisterRegister 
 ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

Regular Manifold


 
Post new topic    
View previous topic :: View next topic  
Author Message
Fritz Maurer
Long Time User


Joined: 14 May 2011
Posts: 1072


Report to Moderator

PostPosted: Sun Jan 27, 2013 4:05 pm    Post subject: Regular Manifold Reply to specific post Reply with quote

Is this manifold gas only? It has no heater flaps or anything. Thanks, Fritz

 
Back to top
View user's profile
Oldiron29
Tractor Expert


Joined: 22 Oct 2007
Posts: 1502
Location: Suffolk, NY

Report to Moderator

PostPosted: Sun Jan 27, 2013 4:15 pm    Post subject: Re: Regular Manifold Reply to specific post Reply with quote

Fritz, To the best of my knowledge. That is the only manifold for a Regular. Because of the exhaust heat going down past the carb it is heated enough to burn kerosene. oldiron29
 
Back to top
View user's profile
Fritz Maurer
Long Time User


Joined: 14 May 2011
Posts: 1072


Report to Moderator

PostPosted: Sun Jan 27, 2013 5:12 pm    Post subject: Re: Regular Manifold Reply to specific post Reply with quote

Thanks, I thought it might be an option, because of the factory-looking plug and nut assembly on the second inlet of the fuel bowl, pointing toward where the starting tank would be.
 
Back to top
View user's profile
Tom Fleming
Tractor Expert


Joined: 06 Jun 2007
Posts: 2506
Location: pennsylvania

Report to Moderator

PostPosted: Sun Jan 27, 2013 5:12 pm    Post subject: Re: Regular Manifold Reply to specific post Reply with quote

I agree with Oldiron. I have never seen any other type of manifold for a regular except for the one to convert it to an updraft exhaust.
 
Back to top
View user's profile
Display posts from previous:   
Post new topic    Yesterday's Tractors Forum Index -> Farmall & International Harvester (IHC) All times are GMT - 8 Hours
Page 1 of 1

 
Jump to:  
TRACTOR   PARTS TRACTOR   MANUALS
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F).  Expedited shipping available, just call!  Most prices for parts and manuals are below our competitors.  Compare our super low shipping rates!  We have the parts you need to repair your tractor.  We are a Company you can trust and have generous return policies!   Shop Online Today or call our friendly sales staff toll free (800) 853-2651.

YT Home  |  Forums Home

Copyright © 1997-2014 Yesterday's Tractor Co.

Powered by phpBB © 2001, 2005 phpBB Group

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters