B govener weights

[JDJACK]

I am looking for 2 govener weights part #ac667r.
they are still avaible through deer at $118.00 each.
Anybody know of a different source.
 

[rick deere]

I have some out of a 1950 b john deere id sell email is open
 

[JDJACK]

was looking for new
 

[JDJACK]

The 1950 B's are a different part number. Not sure if they fit.
 

[Harvey 2]

John Deere has gone crazy with their prices on the old tractors. Seems like they have the attitude that if people want to keep the old tractors running, they are going to pay (dearly) at that was a pun.
 

[Mike Aylward]

Nearly any Waterloo two-cylinder tractor (except the late B and D's, possibly others) use this same weight. Good ones should be available in any salvage yard. Mike
 

[rickdeere]

i also have a good set in a modle H john deere would they be the same?????
 

[MSD]

You can put oversize pins in if the weights themselves are good yet.
 

[Big Jugs]

Don't pay for new. Just redrill, bush out, and new pin.
 

[wilamayb]

I'm with the others in saying just repin the old ones. Also put the radius back on the fingers so that they dont hang on the flat spot when contacting the bearing race. Make them round and silky smooth. install a new throttle spring and you'll be impressed at how well your governor controls engine speed.
 

[Mike M]

I have a 5105 tractor and priced a seat and tie rod ends $$$$$ WOW !!!! Seat covering is cracked apart as is the boots on the tie rod ends that they don't sell seperately.
Nothing is cheap priced anymore. Just cheaply made.