Yesterday's Tractor Co. Parts for Farm Tractors - Compare our Prices!
Click Here or call 800-853-2651 
   Allis Chalmers Case Farmall IH Ford 9N,2N,8N Ford
   Ferguson John Deere Massey Ferguson Minn. Moline Oliver
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   Traditional YT Forum ViewClassic View   RegisterRegister 
 ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

Ford NAA Throttle plate disconnected - missing screws


 
Post new topic    
View previous topic :: View next topic  
Author Message
debkinneer
New User


Joined: 11 Feb 2013
Posts: 2
Location: PA

Report to Moderator

PostPosted: Mon Feb 11, 2013 4:11 pm    Post subject: Ford NAA Throttle plate disconnected - missing screws Reply to specific post Reply with quote

NAA Ford engine suddenly went full bore and I just turn off the key. Throttle linkage seem ok. I removed the Carb. Found the throttle plate disconnected inside and no screws.

Do I have a bigger problem with the missing screws?

If so, any suggestions.

Thanks for your time.
 
Back to top
View user's profile
JMOR
Tractor Guru


Joined: 13 Aug 2007
Posts: 15656


Report to Moderator

PostPosted: Mon Feb 11, 2013 4:16 pm    Post subject: Re: Ford NAA Throttle plate disconnected - missing screws Reply to specific post Reply with quote

debkinneer wrote:
(quoted from post at 20:11:09 02/11/13) NAA Ford engine suddenly went full bore and I just turn off the key. Throttle linkage seem ok. I removed the Carb. Found the throttle plate disconnected inside and no screws.

Do I have a bigger problem with the missing screws?

If so, any suggestions.

Thanks for your time.
Just buy more........& stake them this time.
They are soft brass & probably already gone on through, like the penny a kid swallows.
 
Back to top
View user's profile
debkinneer
New User


Joined: 11 Feb 2013
Posts: 2
Location: PA

Report to Moderator

PostPosted: Mon Feb 11, 2013 4:25 pm    Post subject: Re: Ford NAA Throttle plate disconnected - missing screws Reply to specific post Reply with quote


Thanks ! That is good news. I am glad to hear that I was over thinking it.
 
Back to top
View user's profile
Display posts from previous:   
Post new topic    Yesterday's Tractors Forum Index -> Ford All times are GMT - 8 Hours
Page 1 of 1

 
Jump to:  
TRACTOR   PARTS TRACTOR   MANUALS
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F).  Expedited shipping available, just call!  Most prices for parts and manuals are below our competitors.  Compare our super low shipping rates!  We have the parts you need to repair your tractor.  We are a Company you can trust and have generous return policies!   Shop Online Today or call our friendly sales staff toll free (800) 853-2651.

YT Home  |  Forums Home

Copyright © 1997-2014 Yesterday's Tractor Co.

Powered by phpBB © 2001, 2005 phpBB Group

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters