Recent content by bcliburn

  1. B

    135 runs like crud all of a sudden

    No it was 7 ohms of resistance 7.2 if I remember correctly I used my good fluke meter I use at work everyday that's why I think it was bad they said anywhere from 1 to 3 ohms of resistance was normal
  2. B

    135 runs like crud all of a sudden

    No I'm not sure I'm guessing the coil since it had alot more resistance than it was supposed to. I should have replaced one at a time but just put them on the same time.
  3. B

    135 runs like crud all of a sudden

    Problem solved or at least I hope! The only thing I hadn't changed was the coil so I took the coil off and checked for resistance on the primary side hade 7 ohms, so I had the wife run by parts store while out grocery shopping and had her pick up new coil and an extra condenser just incase the...
  4. B

    135 runs like crud all of a sudden

    Well I got another doozy and about to throw in the towel on this old girl... today I decides to give it an oil change, so I go get new filter and oil plus a qt of Lucas oil additive thinkin an old tractor deserves to be cleaned out a little. So I get the oil changed and turn it over a...
  5. B

    what spark plugs helpp

    I pulled a plug out and it's a long ways past the threads before it opens up, I also noticed that it makes no diff for me because it has had to short of plugs in it for so long that it has the last few threads which the 3/4 in reach would probly hit are carbon covered/ rusted to the point...
  6. B

    what spark plugs helpp

    So I just got home and took a plug out, the wierd thing to me is that the hole extends at least 3/4 to a inch past the threads toward inside of motor. I put the autolite 347 in it since it was 7/16 reach after talking to my dad he said since it's running fine with the 7/16 reach already...
  7. B

    what spark plugs helpp

    is there anyway if i count thread number on head and get plugs with same number of threads would this work?
  8. B

    what spark plugs helpp

    i absolutely cannot find the right spark plugs for my 69 135 with 3 cyl, not sure what reach, i called a couple mf dealers they are no help i wanna put a little hotter plug in it then is in it now. its got autolite 216 in it when i bought it but i think they are wrong. all iv been able to find...
  9. B

    compression test

    Thank you for all the help
  10. B

    compression test

    Ok so I just got done, I pulled plug disconnected dist from coil, cranked motor until gauge stopped climbing 4 or 5 cranks and on each cyl had 150 did each one 3 times just to be sure. Drained my dang battery to haha but all were equal to one another so I guess that's good
  11. B

    compression test

    I am Goin to attempt to do a compression test on my 135 with 3 cyl gas, anyone have the stops for this process do I take all spark plugs out etc. And what should my compression be thank you
  12. B

    massey ferguson 135

    How would I check the timing
  13. B

    zenith /bendix carb

    Ok that makes me feel alot better! I guess I just didn't exactly know what is normal for it but sure makes me feel better getting some input from someone who has the same tratctor, I'm just gonna be doing light brushogging and pull a little 5 ft disc for food plots, just wanted to try and get it...
  14. B

    zenith /bendix carb

    I have a 135 with 3 cyl gasser and I took carb off cleaned it and noticed there is no adjustment on the bottom jet, the only adjustment is on the top right for I'm assuming idle? But the tractor stumbles on throttle and picks back up I'm thinking it's a bad coil but didn't know if it was normal...
  15. B

    massey ferguson 135

    perfect I'll try that and see what I come up with thanks for the help
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top