-
J
Ford 4000 engine rebuild
Thanks Sir, If i can get through this one I have a 1963 MF35 diesel my dad bought new in 1964. I started farming with it in the early 70"s. I would like to restore it. I"m with you on manuals, whenever i bought any equipment I told dealer I had to have an owners manual -
J
Ford 4000 engine rebuild
I will try swapping #1 and #3 pistons and see if that helps since #1 is .022 and #3 is .028. -
J
Ford 4000 engine rebuild
It is my first and maybe my last. I have 2 different manuals and mine don't have much info either -
J
Ford 4000 engine rebuild
Thanks Welding Man, This engine had been rebuilt some time in the past before I got it. Don't know if it was decked then or not. We didn't deck it this time. Did bore it .020. Guess i will just have to install head and see if pistons hit. Beginning to wish i had never started this rebuild. It's... -
J
Ford 4000 engine rebuild
Thanks for the reply Destroked 450. I saw a technical bulletin from A&I products that said with the thicker gasket new piston height is .014 to .026 if i am reading it correctly. If you think .028 on the one cyclinder is too much what should i do? -
J
Ford 4000 engine rebuild
I have a 1970 ford 4000 3cyl diesel. I am in the process of rebuilding the engine. It had a broken crankshaft. I put everything new in but the rods and the piston height above the block was .028 to .038. I figured rods could be stretched because of the broken crankshaft so I installed new rods...
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy