-
M
3 point hydraulic trouble
Thanks all. I made a rookie mistake. Replaced a 3 inch cylinder with a new 2 inch cylinder because it was in stock. I now have a new 3 inch cylinder installed and my 3 point has adequate lift again.- Mmaiani
- Post #1
- Forum: Oliver, Cletrac, Co-op and Cockshutt
-
M
3 point hydraulic trouble
I have tried that, with no effect. It just switches which way the lever is pushed to go up or down. I cant find anywhere in my manual if there is a filter or screen for the hydraulics, and cant find one by looking at the tractor. Was also wondering if possibly the new cylinder with 2500 PSI...- Mmaiani
- Post #1
- Forum: Oliver, Cletrac, Co-op and Cockshutt
-
M
3 point hydraulic trouble
I have a 1953 Row Crop 77 with Hydralectric controls. None of the electric controls have been functional in the years Ive owned the tractor. Ive always used the hand levers with no problems. Last week, I set out to repair the hydraulic cylinder for the three point because it was leaking so...- Mmaiani
- Thread
- Replies: 8
- Forum: Oliver, Cletrac, Co-op and Cockshutt
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy