(800) 853-2651
SHOP NOW

Search results

  1. B

    4020 hydraulic oil in clutch housing

    I removed the support tube to where I can kind of see the seal now. Did you make a driver for installing the seal? How did you remove it? Guessing the clutch release fork and tube will fit through the hole? Thanks
  2. B

    4020 hydraulic oil in clutch housing

  3. B

    4020 hydraulic oil in clutch housing

    Thanks for the replies, I’ll replace the packing also. This is going to sound like a crazy question. What if I replace everything I can get to with a clutch split, put it back together, and still have the leak I’m guessing it would about have to be the PTO seal then. So can I just split it at...
  4. B

    4020 hydraulic oil in clutch housing

    I am going to replace that seal, I have the old seal off and the bushing felt pretty good. It is dry around that seal. I haven’t put it back together and proven that the pto pistons aren’t the problem but didn’t do enough research before taking it apart. I had assumed that everything that could...
  5. B

    4020 hydraulic oil in clutch housing

    I have a newer 4020 syncro split for a bad traction clutch. I knew it had hydraulic oil getting into the clutch housing but just assumed it was the o-rings on the actuator for the PTO clutch. Due to my lack of experience I did not remove the bottom cover and try to see where the oil was coming...
  6. B

    3020 steering valve Tim s?

    Tim, Thanks for the reply, I’ll be sending you an email.
  7. B

    3020 steering valve Tim s?

    Just posting this to possibly get in contact with Tim s, we are getting to take a steering valve out of a 3020 that “wandering”. I’ve seen in past posts that you rebuild these, is this something you still do? If so, what’s the best way to get in touch with you?
  8. B

    CharLynn power steering on 770

    Thank you, that helps a lot, now I have an idea of what I need to try and make.
  9. B

    CharLynn power steering on 770

    I guess finding one is probably going to be a long shot?
  10. B

    CharLynn power steering on 770

    Im trying to install a power steering system onto a 770, it was taken off of an 880. I think Im missing a bracket for mounting the pump. I was hoping maybe somebody would have a picture of how the pump mounts to the engine? Photo is of the pump and the only bracket I have with it. Thanks
  11. B

    Super 55 PTO does not engage

    If you havent had trouble with drive clutch , I wouldnt mess with it. Its not a bad split, get you a shop manual if you dont have one. Every time Ive had one that wouldnt adjust to snap in, its been in the discs.
  12. B

    Oliver 550 pto clutch problem

    Theres a roll pin inside gear case where that shaft goes into the actual PTO shaft, Ive had to repair one that the pin was broken on. You have to remove rock shaft cover to access.
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top