Search results

  1. 4

    J D advertising enamel signs

    Sign is an authentic from "40's or earlier It was face down on an old workbench when I recovered it hence chipped enamel from hammer strikes
  2. 4

    J D advertising enamel signs

    Have an enamel dealer sign about 24" by 54" (approx) Sign is red black and yellow (!no green) jumping deer is 3 legged! Any insight as to age?
  3. 4

    J D 420C....... Want to adjust allignment of track frame on crawler. Any advice on getting clamp bolts loose?

    Any advice on getting track clamp bolts on 420 C loose..... want to adjust allignment.
  4. 4

    420 oil pressure

    Oil pan easy to remove unless dozer frame is in the way. Also protective pan under oil pan has to come off
  5. 4

    1965 Ford 5000 water pump bearing and seal replacement

    Looking at replacing bearings and seal in 5000 ford water pump,,,1965 diesel.... advice?
  6. 4

    Any comments or advice on installing crankcase guard on J D 420C?

    On my crawler heads of bolts are inside housing and nuts outside pan. Pan has to be sprung wider to go over bolts. I initially thought nuts inside and outside of pan but that doesn't fit. Casting is not threaded.. it is moulded so bolt head fits in a recess and won't spin. Don't want...
  7. 4

    Any comments or advice on installing crankcase guard on J D 420C?

    Large bolts that hold rear of pan are loose when nuts are removed are they free to slide into flywheel housing or will they contact flywheel and stay in place? I may just cut slits in pan so can slide into place with nuts on..... J D pan in nowhere near as heavy as pan on my D 2 5 U!!!
  8. 4

    Any comments or advice on installing crankcase guard on J D 420C?

    Any comments on installing crankcase guard on 420 C?
  9. 4

    420 C tracks

    I found also Jensales manual had no info on track wear. D2 caterpillar manual is very detailed... I think 3 and quarter inch from pad to wear surface and cat links are wore out... Would like to know when J D links are done... I don't think welding up is an option....pins will loosen...
  10. 4

    420 C tracks

    Any info on height measurement of track links on 420C?
  11. 4

    J D 420 C engine questions (governor)

    Weights in 420 C engine governor have extended out far enough to wear a track out of inside of governor housing. Question is should there be washers or shims on shaft to prevent travel this far? Perhaps someone has a parts manual or experienced this and has comments or advice. Thanks...
  12. 4

    420 C engine questions

    Working on 420 C.... Engine must have over sped and governor weights wore out some of inside of housing.... Should there be shims on shaft to prevent weights from moving too far?
  13. 4

    420 C engine questions

    Am repairing a 420 C engine! Former owner ran with zero oil pressure and took out bearings on crank. Crank has been polished and still measures standard!!!! Pistons in engine were .040 oversize not .045 sold by J D. Question is did these foreign pistons cause failure? What is proper deck...
  14. 4

    420 C engine questions

    repairing 420 engine.. Putting in .040 oversize pistons that were in engine when I aquired it.J D pistons are standard , ,045 .090 and ,135 oversize. Are J D pistons flat top or do they haxe a recess to lower compression ratio? What is proper deck height?

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top