(800) 853-2651
SHOP NOW

Search results

  1. ptfarmer

    Canister oil filter for 180

    There is a spin on oil filter kit, Sparex S41489
  2. ptfarmer

    Ford 4500 seized engine/clutch

    My 4500 was in bad shape, but if you can do all the labor it's not expensive to rebuild (like I did mine).
  3. ptfarmer

    Ford 3400 CAV dpa injection pump shut off on it's own

    I get the fuel for all my tractors at the same place, I buy it as needed so it goes right in the tractors (this is the only tractor I had a problem with algae). I bought a can of biocide for $35
  4. ptfarmer

    Ford 3400 CAV dpa injection pump shut off on it's own

    Got around to fixing it, after only 25 hours after having throughly cleaned/dried out the fuel tank, replacing the fuel tap/screen, the screen on the new tap was plugged up with algae. Always fun to pull the tank to clean it out again.
  5. ptfarmer

    Spin on oil filter for Z134 good G176?

    It should fit, the Z134, and G176 engines use the same canister type oil filter, oil filter cover, and oil filter retaining bolt.
  6. ptfarmer

    135 front hydraulic pump yes or no

    This is the parts you need Unless you can find a used bracket to mount the pump you need to make one, or have it made
  7. ptfarmer

    Ford 3400 CAV dpa injection pump shut off on it's own

    Have a strange problem on my 3400 with the dpa injection pump. While the engine was idling it reved up a little bit, and idled right back down (it puffed out a little black smoke when it reved) it did that 4 times in about a minute then it just shut itself off, and now it won't start. I'm...
  8. ptfarmer

    MF-50 Diesel: help sourcing fuel line to injection pump

    I usually make them from steel brake lines using the old nuts from the old fuel line. Here are the part numbers.
  9. ptfarmer

    Massey 205 diesel 3 pt hitch weight limit?

    Your 205 has outboard planetaries that have their own oil (90wt gear lube) that is separate from the rear differential (about 1 quart per side). That oil probably has never been checked, or changed, I would make exactly sure to find exactly where the noise is comming from because going through...
  10. ptfarmer

    Massey 205 diesel 3 pt hitch weight limit?

    The 3 point should be able to lift 2850lbs, it should be able to hold a load up for a little while (if you can visibly see the 3 point drop down it needs seals). The pedal forward/reverse transmission makes it a good tractor for front loader work, but no so much for anything else except for...
  11. ptfarmer

    Massey Harris 50 High Altitude

    SHGM- S=standard width, G=gas, H=high altitude, M=dual clutch, 510328=1956 year model
  12. ptfarmer

    Massey Harris 50 High Altitude

    The "high altitude" engine just had a higher compression ratio so it can make the same power at higher altitude. The compression ratio is about 8.0:1 for the high, 6.0:1 for the low (maybe about 20-30 psi between the two when measured at the same altitude) todays "cheap" gas/fuel is better...
  13. ptfarmer

    1974 ford 3400 with 6x2 transmission

    I have one, but I wish it was the mechanical shuttle.
  14. ptfarmer

    MF 40 New pistons hitting valves!

    If they all 3 have the same part number I'd say 1 was machined wrong (just because they are new doesn't mean they are good). Get a caliper, and get to measuring
  15. ptfarmer

    MF135- Wet Brakes

    I'd say it's definitely an orchard model, some of the 150's, and all the 165's, 175's have the same disk brakes as your 135. I would suggest draining the oil out of the planetaries, most don't know they have their own oil so it never get's changed (they use 90wt gear oil).
  16. ptfarmer

    MF135- Wet Brakes

    The 135 orchard model had the inboard disk brakes along with the non-adjustable front axle (I do believe those brakes are supposed to be dry, not wet). The housings that are outboard by the wheels are plantaries.
  17. ptfarmer

    4500 TLB brake rod seal

    Get the new rod seals from New Holland, the cheap aftermarket ones fail quickly.
  18. ptfarmer

    4-51 Detroit Diesel

    Time to find a MH 44, and put it in there, and have some fun with it I'd say!!
  19. ptfarmer

    4-51 Detroit Diesel

    It still has rocker arms to run the injectors.
  20. ptfarmer

    4-51 Detroit Diesel

    A super rare engine, not very many made, my quess is that someone was trying to cobble something together (no M-H used that engine). A video (not mine) of a 4-51 running.
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top