Search results

  1. M

    injector timing and low engine torque

    thank you for all your help , I will look through the manual for this .
  2. M

    injector timing and low engine torque

    I am not convinced that the engine is .I put remained injectors in it and had one stick open not long after i put them in. It could very well be fuel related or even sucking air in the fuel line some where , it just seams like the E-break is dragging but it rolls freely when its out of gear ...
  3. M

    injector timing and low engine torque

    Would that cause the engine to run a little hot over time? Like slowly heat up after about 30 min of use.
  4. M

    injector timing and low engine torque

    new engine , new injectors engine runs great just don't have much torque, ford backhoe 256ci 4cy , new filters . Acts like the the fuel filters are clogged but they are new.
  5. M

    Ford 555c air out of the injector pump

    Well if its going to happen its going to happen to me. Ill update when I get it replaced.
  6. M

    Ford 555c air out of the injector pump

    wow I would have never thought about the air coming from the injector but that makes sense that its just one line. I just put new injectors in it and have about 5 hours on them. I will check that this evening.
  7. M

    Ford 555c air out of the injector pump

    92, 555c I have air in the lines at #4 injector line out of the back of the injector pump but its only #4 when I crack the lines on 1-3 the engine sputters with no air just fuel . when I crack the fuel line on #4 engine does not change and I get fuel with lots of air, is the pump bad ? I am...
  8. M

    555c ford backhoe getting hot under a load

    if you take it out of gear it rolls like it should , I am having the radiator rodded out to eliminate that, i did not own it before the rebuild, 1996 555c that sat for about 6-8 years and the engine had water in one cylinder due to the air filter being removed ,backhoe runs flawless but in drive...
  9. M

    555c ford backhoe getting hot under a load

    when in gear , forward or reverse it feels like the brakes are dragging but when you put it in neutral it rolls nice and easy , engine gets hot when you push a little load , engine has about 20hr on a fresh rebuild , could the trans filter be stopped up , the trans oil looks very clean, seams to...
  10. M

    4 cyl. ford 555c engine hunting

    I agree , any idea how to check that governor to see
  11. M

    4 cyl. ford 555c engine hunting

    that push button primer does leak when you use it and now that i think about it there is some wet dust collecting around that area. I will look at it first thing when i get home.
  12. M

    4 cyl. ford 555c engine hunting

    1992 555c ford back hoe engine hunting at mid rpm range and at idle , I am thinking a bad injector seeing as all filters are new. getting a little black smoke when you accelerate.
  13. M

    ford backhoe hydraulic hose fitting size

    Any one know what the hydraulic hose fitting type on a ford backhoe. I have to replace all the hoses and I am looking for the best economical way to do it.
  14. M

    Ford 555c brake issues

    well thankfully I owe you an a apology , it was the lugs loose , they were very loose , couldn't tell until I got them off the ground
  15. M

    Ford 555c brake issues

    The brakes were stuck when I went to load it. Had to rock it back and forth to free it up . All the lugs are tight
  16. M

    Ford 555c brake issues

    555c ford backhoe , been setting for quit a few yrs and now that its moving the rear wheels seem to be popping sometimes like the brake is sticking but i dont feel it I just hear it. Is this something to be concerned with or is it in need of just working it lose
  17. M

    water in hydraulic system

    Well that makes me feel a little better. I have about 10 ac. of stumps to dig up so its going to get a workout . I will dig through the posts and see what i can find . I apricate all the info you guys on this forum have been a life saver.
  18. M

    water in hydraulic system

    That would be a lot of condensation, the oil is WHITE. The fact that the pump was exposed to rain for a long period of time. I would be ecstatic if it was just condensation.
  19. M

    water in hydraulic system

    It's been sitting for about 10 yrs . Rebuilt the engine . They had the pump covered but it must have been leaking . I should have drained it before starting it the first time . But I didn't and now the oil is milky and needs to be drained and flushed , possibly several times

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top