(800) 853-2651
SHOP NOW

Search results

  1. O

    1951 WD Wiring Mess

    Thank you for your help. I think I have it figured out. I'll keep a fire extinguisher handy just in case.
  2. O

    1951 WD Wiring Mess

    Great information, Thank you.
  3. O

    1951 WD Wiring Mess

    Thank you for the reply. Is there a wiring diagram for an alternator somewhere? And how much trouble is it to make a bracket for the alternator? Thanks again.
  4. O

    1951 WD Wiring Mess

    Hello all, I have a 1951 WD project that I could sure use some help with. The battery does not charge, but the tractor runs very good until it has been started enough time to drain the battery. It has a 12v battery, positive ground and has a distributor with a coil with the resistor built in...
  5. O

    WD Keeps Dying

    Thank you everyone for the comments. I put a new points and condenser set in it and so far it has not had any more problems.
  6. O

    WD Keeps Dying

    Thank you for the help. That will be my next move.
  7. O

    WD Keeps Dying

    Hello all, I have been struggling with WD Ser.#97728 that keeps dying after it gets warmed up. It has always ran pretty good until this spring. The first time it was used it would hardly turn over, the battery would not hold a charge so I replaced it. It would start right up but die after it...
  8. O

    Mag timing on an LI

    So you used the TDC line for your reference point to mount your mag and didn't use the spark line? I'll give that a try. Thank you.
  9. O

    Mag timing on an LI

    Thank you, I will try again when I get home.
  10. O

    Mag timing on an LI

    Hello everyone, I am trying to figure out how to get a magneto timed on a 1939 LI. The mag is a WICO XH 909. According to the manual with the magneto removed, line up the Spark mark on the flywheel with the mark on the timing hole. The point gap is set to .015. Next it says to hold the mag in...
  11. O

    Parts for Massey Ferguson 1655

    Thanks again everyone for your information. The tag on the engine shows BF-MS 3221E. I am in need of part #537 115 M91 "adapter assembly, engine" and the splined coupler for it and the "pulley assembly drive" part"#3 21 333 M91. New parts are probably not available so if anyone may have used...
  12. O

    Parts for Massey Ferguson 1655

    Thank you very much for the numbers. I get one.
  13. O

    Parts for Massey Ferguson 1655

    Thank you everyone for your input. I need an ignition switch because the one that's on it does not have a key. It has 5 prongs on the back of the switch but the only number is a patent number. I will try to get into it deeper this weekend. I would like to get the fuel tank cleaned out, change...
  14. O

    Parts for Massey Ferguson 1655

    Hello all, I just acquired a Massey Ferguson 1655 garden tractor that is currently not running. I know nothing about Massey Fergusons or where to get parts. I was hoping someone could point me in the right direction for new or used engine parts, chassis parts and possibly a place to get a FEL or...
  15. O

    What are some big tractor shows?

    Midwest Old Threshers Reunion in Mt. Pleasant, Iowa. Same time every year, 5 day event ending on Labor Day. http://www.oldthreshers.com/ On the "Reunion" tab, go to "Areas Of Reunion" and scroll down to "Tractors" to see several photos.
  16. O

    Marvel Schebler TSX 877 carb- What does it fit?

    Check out this web page. if you do the "edit find" and type in 877 and hit the next button 4 or 5 times it will list one in the john deere 45 combine section. Hope this helps. http://www.tomco-inc.com/Catalog/agricutural&indust.pdf
  17. O

    John Deere B won't start

    This might be stupid of me but have you checked for a stuck float in your carburetor? May be flooding?
  18. O

    a different kind of project......ford F150

    I have seen several instances where cooling problems like this are caused by a bad head gasket. What does your oil look like? Sometimes you can tell if a head gasket is leaking by pulling the spark plugs to see if coolant is getting into a cylinder. If you ever remove the plugs be very careful...
  19. O

    34 A oil pump

    Our 34 A does the same thing so we have been using Lucas Oil in it and have never had to grease the gears again.
  20. O

    Sediment bowl questions

    Thanks Mike. Some of the littlest parts have some interesting history.
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top