(800) 853-2651
SHOP NOW

Search results

  1. S

    Ford 3000 timing

    IF ITS RUNNING GOOD.... dont pull the distribitor unless your know how to retime it.!!!!!!!!!!!!!!!!!! Dont make it worse. As others have said.. find tdc, and then clean the flywheel and paint the mark..
  2. S

    Too Many Flat Tires

    Slime works very well if the tractor is used often, and the slime is circulated. BUT.. when you park it for a long period, the slime is in the bottom and the holes are on top, and will start leaking slowly... SO.. Dad always had a rule.. You must always park the tractor withing reach of an air...
  3. S

    Too Many Flat Tires

    Every now and then, I get a tractor in that has " rice " tires on the rear... Due to the extremely long/tall O lugs, these rear tires are almost immune from getting thorns close to the carcass. So I will try to swap them to one of my "ranch" tractors. One tractor had a set of kevlar forestry...
  4. S

    Too Many Flat Tires

    Call " 1 800 no flats"... gensco tire company.. they get 22 ply aircraft tires, cut the 2 inch beads down, and mount them on ag rims with a guard around the valve stem... I have used them for over 40 years now with success. The first pair finally rotted apart after 40 years of use so they are...
  5. S

    Mice urine smell in car

    Panther urine will stop the mice from occupying your car. Use just a few drops sparingly.
  6. S

    Ford 5000 with 5 front weights

    Run an ad on craigslist with a picture.. fits a LOT of fords 65 and up....
  7. S

    Old Ford ID and an issue

    ok,, its also a diesel, trans pto, and 6x4 manual trans... based on the numbers... If you recently replace the filters, are you sure you bled all the air out of the fuel lines so that it can start???? or has it been running since you did the fuel filters?
  8. S

    Ford 7000 Clutch and Turbo

    iirc.. there is a key or converter... that converts the big drive into a smaller drive that the tach cable will fit correctly.
  9. S

    Old Ford ID and an issue

    Probably feb15, 1977 date,, and prob a 420... but upper clutch housing.. starter side, there is a third number... guessing its a "kd2xxx which will tell us the exact model and config.
  10. S

    5640 Loader Valves

    Using a open center remote on the loader..... so that the fluid is returned to the rest of the system. Here is an application on a 5610. Note he added the second pump to the priority valve to add the dual pump scenario for the rest of the tractor. So its open center on the bottom and closed...
  11. S

    5640 Loader Valves

    You CAN.. install a hv4903 under the priority block... if there is room... No cab, there is plenty of room... with cab????
  12. S

    Ford 4500 loader & hoe identification help. Tractor is S/N D5011K, loader and hoe painted over

    I bought a lot of harbor freight wrenches,, cut them down with a torch,,, just to get the hoses off my hoe. be sure to draw a diagram of where all the hoses run,,, especially is they are not straight across and they all flip and twist like mine did. unless your selling the hoe, get quality...
  13. S

    Ford 5000 with 5 front weights

    I seen them called "watermelon" weights down here, but "pillow" is good also....
  14. S

    What model is this loader?

    . but any good hydraulic shop will rebuild those cylinders... I have seen industrial tractors with the early sheet metal on them even though they were made after mid 1968. Dont know it this was a "thing" or not... Looks to be a 730 loader..your loader could have the hooks on the back side to add...
  15. S

    Ford Power steering pump relief valve.

    Did not think of using superglue... Nice...
  16. S

    Ford 3000 Clutch issues

    Which transmission does it have?? if 8 speed, are there two holes on the arm that comes out of the clutch housing???
  17. S

    4R100 transmission on 2000 F550 with 7.3 diesel

    Same problem.. had torque converter upgraded to stop the slipping/heat problem.
  18. S

    Replacing Finish Mower with a Zero Turn

    The air cooled 3800 rpm engines will have a shorter life than the very expense diesel 1800 rpm water cooled engines.. It seems to me that I can get around 600 to 700 hours out of a cub cadet for 3000 bucks... or go buy a kubota $11,568 diesel lawn mower and get 1500 to 3000 hours.. but that is...
  19. S

    Ford 4000 HD industrial backhoe diesel with Elenco 4X4

    That person has more in it than he can ever possible get out of it. Its worth more as a collection item than is is as working machine... And some parts will be impossible to get.. SO.. as a working hoe, $3500. As a collection hoe, maybe $10k???? There are newer and much more capable hoes out...
  20. S

    Old coats tire changer

    had one like that when I worked in a gas station as a kid.... still used hot patches... till rayon tubes came out... Poof!!!! no tube.
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top