(800) 853-2651
SHOP NOW

Search results

  1. J

    Massey 360 power steering

    I have a Massey 360 and the power steering is getting tight. It seems the power steering cylinders are run off the hydraulic pump. The fluid is full in the rear housing. Is the filter clogged or am I missing something?
  2. J

    860 cutting off

    So what is the best way to run the fuel line? Front,rear, original? Is there an insulated fuel line available? I really think the fuel is boiling. The flow is good, its just hot when you pull the line off. I believe I have been just draining the hot fuel out of the line and it runs good...
  3. J

    860 cutting off

    So far I have replaced the shutoff on the bottom of the tank, the fuel line goes around the back of the motor out the other side and slightly downward and then up to the carb where it connects to the glass bowl. It is new rubber fuel line. The glass bowl has a new screen. It looks like it...
  4. J

    860 cutting off

    I really think this thing is vapor locking. When I take the line off, the gas is hot. When the fuel from the tank finally gets to the carb, and bowl, which is mounted to the carb, it's cool again.
  5. J

    860 cutting off

    The cap is off and the flow is good. It does take a moment for it to start. The tank strainer is new.
  6. J

    860 cutting off

    I have an 860 that is cutting off pretty frequently. I have made sure I have spark. I have changed the points, condensor, distributor cap, coil, wires and plugs. I seem to be having a fuel delivery problem. After running a while, it just cuts off. I remove the fuel line from the carb and...
  7. J

    NAA head gasket and valves

    Adjusted the valves and all is well. Thank you!
  8. J

    NAA head gasket and valves

    I replaced the head on my NAA and now the valves or rockers rattle really noticeable. I took the valve cover off and made sure it was oiling and it was. Are these head gaskets a different thickness and the valves should be adjusted after a head gasket replacement? Is it something else?
  9. J

    Hydraulic top link extension needed

  10. J

    Hydraulic top link extension needed

    I do not have the original top link. The hydraulic top link is what was on it. You are correct, I cannot ask the previous owner, and dementia is brutal. This post was edited by Jamie in NC on 01/29/2023 at 02:03 pm.
  11. J

    Hydraulic top link extension needed

    I just inherited a Massey 360 and it came with a hydraulic top link. When I hook my disk up and start to use, the back gang doesn t go down enough with the top link fully extended. Is there an economical way to make an extension to make it longer?
  12. J

    232 o 236 loader

    I am looking for a 232 or 236 loader for my MF360 near NC. What do you use besides Craigslist to find these?
  13. J

    1964 MF 35. Neutral safety switch?

    Thank you so much! I will check that when I am back at the tractor. I appreciate the pictures!
  14. J

    1964 MF 35. Neutral safety switch?

    I will look again, I didnt notice anything in that area.
  15. J

    1964 MF 35. Neutral safety switch?

    Does this model have a neutral safety starting switch? My dad and I were bleeding the injection system and his started in gear, almost causing a catastrophe for me. I have looked all over the transmission and did not see a plug or switch for wires. If so, can you all send me some pictures of...
  16. J

    860 backfire and alternator fuse

    If this is a duplicate, I apologize.I tried to edit and not text shows on my end. I used a 14 gauge 4 inch fusible line. It had a ring connection on one end and I attached that directly to the alternator. I then just spliced the other end into the lead wire to the battery. I bet I popped 20...
  17. J

    860 backfire and alternator fuse

    This post was edited by Jamie in NC on 04/30/2022 at 06:52 pm.
  18. J

    860 backfire and alternator fuse

    Update: Took battery charger to the tractor today and charged the battery. It was not low as the charger barely registered any amperage, however I left it on for an hour or so. I removed the fuse and replaced it with a 4 fusible link. The 30 amp fuse was blown. I then replaced the fuel...
  19. J

    860 backfire and alternator fuse

    I will check that when I am at the tractor again. I need to check the ignition switch wiring definitely. There is something different with it over my NAA.
  20. J

    860 backfire and alternator fuse

    I will take the fuse out and charge the battery and report back. Sometimes it wont start in a normal way. What I mean by that is when you have the key in the start position, and the motor is turning over, it doesnt crank until you let go and it goes to the run position. I think, this may be...
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top