Search results

  1. D

    Super A cultivator

    If you need some help in how to mount them please let me know. I have a complete set and have put them on and off many times over the years. They are off right now so easy to picture and explain where they go.
  2. D

    H Fluctuating Engine Speed

    I have a 51 H. Runs well most of the time. This morning I was shredding pasture. A few times the engine would idle down, then after a few seconds it would speed up back to normal. Am wondering if I have a governor problem. Does the governor require periodic lube. I have never done that. If not...
  3. D

    Identify this tractor please

    I agree Missed that detail. Good set of eyes.
  4. D

    Identify this tractor please

    It is an A. The SA has a hydraulic pack under the gas tank. Your picture shows a space where this pack would normally set. I have a 1949 SA so yours must be earlier than that, although not sure how much earlier. Hope this helps.
  5. D

    H Wiring Question

    Thanks to all who responded so quickly. You guys are great. Using the schematic, I traced the wires and found a wire jammed against the resistor coil that had shorted out due to the resistor heat. Once I eliminated the short, everything worked as it should.
  6. D

    H Wiring Question

    I have a 51H that has a voltmeter instead of an ammeter and a 12V alternator conversion. The light switch is 3-position O/D/B. Currently the lights are on all the time. How do I rewire so that the lights are off in the O switch position and on in the D/B positions. Does anyone have a...
  7. D

    H Axle Problem

    If the problem is just the outboard bearing, can it be replaced through the end cap without PTO removal?
  8. D

    H Axle Problem

    My 51 H has developed a serious grinding noise in the right axle housing. It sounds to me like it is the outboard bearing. Does anyone have any good tips about how best to remove the wheel, and what then must be done to get to the bearing? It looks like a very tough repair Is it? Thanks...
  9. D

    Sprayer for Super A

    Years ago, our family had a sprayer that fit on the back of a Super A. I got the SA, but not sure what happened to the sprayer. As I recall, the frame had two arms that bolted to the upper holes in the rear drive castings. There was another frame support that rested on the drawbar. The...
  10. D

    What Type Plow is This

    NW, not NE OF Waco. Sorry.
  11. D

    What Type Plow is This

    Cranfills Gap, Texas, about 50 miles NE of Waco
  12. D

    What Type Plow is This

    Today I helped a friend pull this plow out of his hedgerow. He just bought the property and has no use for this implement, Can anyone tell me what it is used for and if it is worth anything?
  13. D

    SA Wiring Issue

    Now I get it. Thanks.
  14. D

    SA Wiring Issue

    Bob M, Can you help clarify this point for me. If I remove the ballast resistor, ignition coil and distributor from your schematic #5 for a Hitachi 14231 alternator, how does the ignition switch function on a magneto system? Also, I am using a Denso mini alternator that fits quite nicely under...
  15. D

    SA Wiring Issue

    So then what happens to the wire coming from the ignition switch to the coil. Where does it connect?
  16. D

    SA Wiring Issue

    All these responses assume the tractor has an ignition coil. My SA is outfitted with a magneto. Does this change any of your opinions on how to wire the alternator so it keeps the battery charged? Thanks for the help.
  17. D

    SA Wiring Issue

    I am adding a 1-wire alternator conversion to my 1949 Super A. Does anyone have a wiring diagram that shows the connections to the back of the 3 position switch (low charge/high charge/lights). Appreciate any help offered.
  18. D

    3-Point Mulcher?

    I recently had a large cedar mulcher clear several acres on our ranch. It did a great job but left a lot of material that is still quite large...not log size but just large strips, etc. Does anyone know about a 3-point, PTO driven implement that could be used to run over the shredded material...
  19. D

    H Oil Pressure Problem

    I am trying to bring a 49H back to life. Just had the rod bearings replaced and the engine tuned and it runs really well. However, even at full throttle, after running for a while the oil pressure drops from about 60psi to about 5 psi. This seems abnormal to me. As part of the rebuild, the...
  20. D

    Super A Loader

    I have a Super A with a 1000 loader that I use all the time. It is not used like a loader tractor, but just for general lifting purposes on our ranch. The lift capacity is limited by the hydraulic pump output so if you are not attempting to dig deep, thus lifting the front end off the ground...

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top