pto was working on the bush hog 1000 rpm , switched to 540 for the baler, now it won't run but about 5 seconds shuts off throws a no speed code,
placed a quarter between the shaft and engagement pin, also checked to make sure the reluctor ring was still in place it was, replaced the speed sensor same problem. switched it back to 1000 no change, where is the seat switch located hopefully that is the problem? also is there some way to access the error code to see if i can determine what quit working.
placed a quarter between the shaft and engagement pin, also checked to make sure the reluctor ring was still in place it was, replaced the speed sensor same problem. switched it back to 1000 no change, where is the seat switch located hopefully that is the problem? also is there some way to access the error code to see if i can determine what quit working.
