Allis Chalmers B Plow Setup

[Rugerben]

I have a question on my B plow. Attached are pictures of the frame of the front of the plow. The manual I bought off ebay shows an anchor plate and hammer strap needed to attacht to the final drive but I cannot find an anchor plate anywhere. I checked all the posts about the plow setup and connections and I cannot see any of these anchor plates on your B's either. Given the photos below can someone tell me what I am missing to attach the plow frame to my final drives? Also I don't have a lever up front for depth, just the little brackets seen in the last picture. I have the cultivators on in that pic so try and ignore those! Thanks.

and I know you guys love pictures so here are two more of my little B!

 

[Lonnie Smith]

Here is a bracket for the plow.

 

[Rugerben]

thank you! Any idea on where I could find a pair of brackets?

 

[Lonnie Smith]

I'm sure someone on the other forum would have some. www.nnalert

 

[Aaron SEIA]

Looks like they would be easy to fab with some measurements.
AaronSEIA

 

[chalmersbob(Pa)]

Lonnie is showing you the correct brackets. However there were 2 different types used.
The older drawbar that was curved used a straight drop bracket and the drawbar type that you have uses an
offset type bracket. I have and extra pair if them if your interested. Email me. Bob

 

[Rugerben]

I tried to reply but am not sure if it went through. It doesn't show an email for you Bob so could you email me at [email protected]? I am interested in the anchor plates.