Case 411 Where do I pour this stuff?

[JoeyPorkChops]

Hello and good morning all you head Case(s)

I write that in the kindness way possible.

I would like to get some help regarding Where do I pour this stuff?

I just finished connecting some hydraulic lines and wanted to give the hydraulics a test at this point before I move on.
But then it dawned on me - I didn't know the answer to the following question Where do I pour this stuff?

Also, it is my understanding that I am to use Trans/Hydraulic fluid is that correct?

So two questions
1) Do I use Trans/Hydraulic fluid
2) Where do I pour this stuff?

I have taken a picture of what I believe to be the correct location, please confirm or stop me before I mess something up.

see pictures regarding the location that I add hydraulic fluid too

 

[jon f mn]

Your pic is the relief valve. You put the oil in on top by removing the mushroom looking breather cap. Level is the 1/4 plug on the right side. And trans/Hydraulic fluid is cortect.

 

[oldproudvet]

Find an owners or operators manual, they are readily available reproduced along with origonals off ebay or at swap meets. This would be very helpful to you and answer most of your questions. Larry

 

[nick831]

Couldn't agree more. I bought a manual for my 830 ck and it is amazing the info that is in there and I am a good mechanic. It has helped me with about everything on my tractor.

 

[CaseDC3]

This is where the Hydraulic fluid goes. Through the breather. But, almost every Racine 400 has the plumbing set up. The photo is of my 1956 400.
The full is exactly what Jon said about the 1/4 plug.

 

[JoeyPorkChops]

Hey

THANKS very much. I just saw your post

That helps a lot