U302 Hydraulics for Loader Operation

[GR Gold]

I have a late U302 Super that has a White loader hooked to it and uses the rear remotes to operate the loader. It had a bucket on it but I have just switched it to a hay fork to feed out round bales. What I have noticed is that when using either hydraulic lever with a bale on it, the other function is affected some as well. In other words, when raising the loader, the bale will tilt down a little bit. Also, when rolling the bale back, the loader will drop a little. I am not using the controls simultaneously. What would cause this? I'm guessing fluid is bypassing somewhere. Is there something that can be adjusted? It is not terrible, but annoying just the same. I never noticed it with the loader bucket on it, just the hay spear loaded with a bale. My 670 Super with an Allied 594 loader plumbed in the same way does not do this, and I believe it has the same hydraulic system. Thanks in advance for all your replies!

 

[molinegb]

Am guessing no 3 pt so E type hydraulics?

 

[GR Gold]

Am guessing no 3 pt so E type hydraulics?

It does have a 3 point, and that works very well for raising a bale.

 

[MMDEL]

Check to see if your springs are week on your remote levers. Move each of them one at a time and make sure the other one stays absolutely perfectly still. You may have to center your spools inside the telo-flow, and you will need a manual to do that.