Yesterday's Tractor Co.
Shop Now View Cart
   Allis Chalmers Case Farmall IH Ford 9N,2N,8N Ford
   Ferguson John Deere Massey Ferguson Minn. Moline Oliver
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   Traditional YT Forum ViewClassic View   RegisterRegister 
 ProfileProfile    Log inLog in 

To20 timings marks again

Post new topic    
View previous topic :: View next topic  
Author Message
New User

Joined: 10 Jul 2019
Posts: 3

Report to Moderator

PostPosted: Fri Jun 04, 2021 5:37 pm    Post subject: To20 timings marks again Reply to specific post Reply with quote

Hello all,
Been a fairweathered member here for sometime, enjoy the tractors but don't usually have much help for most, which leads me to the start of yet another discussion of a topic that has been killed many times. I have a To20 with a missing serial plate. I am having a geck of a time getting it timed, my engine block does not have a sight window or a drill hole for finding DC. I removed the starter and i do have the timing marks on the flywheel. I have done the thumb overthe #1 several times, it just doesn't seem accurate. I am going to put on a picture of my starter area, with the sight area brushed down to the cast. Can someone help me with another procedure for timing it? Thanks Tim

Back to top
View user's profile
Post new topic    Yesterday's Tractors Forum Index -> Harry Ferguson All times are GMT - 8 Hours
Page 1 of 1

Jump to:  

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]

YT Home  |  Forums

Modern View Forum powered by phpBB © 2001, 2005 phpBB Group

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters