Yesterday's Tractor Co.
Shop Now View Cart
   Allis Chalmers Case Farmall IH Ford 9N,2N,8N Ford
   Ferguson John Deere Massey Ferguson Minn. Moline Oliver
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   Traditional YT Forum ViewClassic View   RegisterRegister 
 ProfileProfile    Log inLog in 

TO35 Replcement Governor

Post new topic    
View previous topic :: View next topic  
Author Message

Joined: 29 May 2009
Posts: 98

Report to Moderator

PostPosted: Sat Jun 05, 2021 12:19 pm    Post subject: TO35 Replcement Governor Reply to specific post Reply with quote

I bought a replacement governor for my TO35 Ferguson and it has a shim - it doesnt have any instructions and my old governor didnt have a shim. It is a continental 4 cylinder - do I use the shim or not - thanks for the help
Back to top
View user's profile
Duner Wi
Tractor Guru

Joined: 04 Feb 2001
Posts: 4653

Report to Moderator

PostPosted: Sat Jun 05, 2021 6:16 pm    Post subject: Re: TO35 Replcement Governor Reply to specific post Reply with quote

All I know is a little about is Z120-Z129 for T020 and TO30.
On Z120 if replacing flyweight governor with Novi ball governor you use about a .060 shim.
Shim carries a HF part number and is talked about in the IT manual for TO20. So If you had a ball governor on your TO35 and no shim I would look at your old parts and compare to new parts. If you had flyweight governor I would guess you need the shim.
Back to top
View user's profile
Post new topic    Yesterday's Tractors Forum Index -> Harry Ferguson All times are GMT - 8 Hours
Page 1 of 1

Jump to:  

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]

YT Home  |  Forums

Modern View Forum powered by phpBB © 2001, 2005 phpBB Group

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters