Yesterday's Tractor Co.
Shop Now View Cart
   Allis Chalmers Case Farmall IH Ford 9N,2N,8N Ford
   Ferguson John Deere Massey Ferguson Minn. Moline Oliver
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   Traditional YT Forum ViewClassic View   RegisterRegister 
 ProfileProfile    Log inLog in 

IH 574 Loader and three point stopped raising (new noise

Goto page Previous  1, 2

 
Post new topic    
View previous topic :: View next topic  
Author Message
Thats a good boy...
New User


Joined: 02 Jun 2021
Posts: 10


Report to Moderator

PostPosted: Sat Jun 05, 2021 8:23 am    Post subject: Re: IH 574 Loader and three point stopped raising (new noise Reply to specific post Reply with quote

CVPost-JimB2 wrote:
(quoted from post at 06:01:32 06/05/21) Hi, that appears to be a Power Beyond connection to your loader so the rear remote outlets are not connected to the loader, so try Dead Heading the rear remote.

See attached photos and also the link to the European service manuals for the IH 74 Series tractors, the USA Louisville, KY assembled units are slightly different.

Manual 574


Nice, Thank you very much. I will try the dead heading.
I am still waiting for the filters to show up.

This post was edited by Thats a good boy... on 06/05/2021 at 12:33 pm.

 
Back to top
View user's profile
Thats a good boy...
New User


Joined: 02 Jun 2021
Posts: 10


Report to Moderator

PostPosted: Thu Jun 10, 2021 2:10 pm    Post subject: Re: IH 574 Loader and three point stopped raising (new noise Reply to specific post Reply with quote

OK, got my filters yesterday and changed the hydraulic filter, was great right away but the more I used it - it started to shudder at the end of any stroke. Today it ran just fine, what could the shuddering be caused by? I could only think of air in the line but there is no reason air should have gotten that far, I believe.

Again, thank you to everyone that offered assistance, nice group here.
 
Back to top
View user's profile
:   
Post new topic    Yesterday's Tractors Forum Index -> Farmall & International Harvester (IHC) All times are GMT - 8 Hours
Goto page Previous  1, 2
Page 2 of 2

 
Jump to:  

TRACTOR PARTS TRACTOR MANUALS
We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]

YT Home  |  Forums

Modern View Forum powered by phpBB © 2001, 2005 phpBB Group

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters