Yesterday's Tractor Co.
Shop Now View Cart
   Allis Chalmers Case Farmall IH Ford 9N,2N,8N Ford
   Ferguson John Deere Massey Ferguson Minn. Moline Oliver
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   Traditional YT Forum ViewClassic View   RegisterRegister 
 ProfileProfile    Log inLog in 

3010D 24V starter prblems


 
Post new topic    
View previous topic :: View next topic  
Author Message
Deeredawg
New User


Joined: 02 May 2021
Posts: 9


Report to Moderator

PostPosted: Mon Jun 14, 2021 4:23 am    Post subject: 3010D 24V starter prblems Reply to specific post Reply with quote

Can someone please tell me what voltage the yellow wire is supposed to be from the switch to the solenoid. 12V or 24V?
 
Back to top
View user's profile
Deeredawg
New User


Joined: 02 May 2021
Posts: 9


Report to Moderator

PostPosted: Mon Jun 14, 2021 4:26 am    Post subject: Re: 3010D 24V starter prblems Reply to specific post Reply with quote

Sorry. Im having a hard time posting a photo.
 
Back to top
View user's profile
wore out
Tractor Expert


Joined: 01 Oct 2019
Posts: 2778


Report to Moderator

PostPosted: Mon Jun 14, 2021 5:09 am    Post subject: Re: 3010D 24V starter prblems Reply to specific post Reply with quote

CVPost-Deeredawg wrote:
(quoted from post at 05:23:57 06/14/21) Can someone please tell me what voltage the yellow wire is supposed to be from the switch to the solenoid. 12V or 24V?


If the batteries are connected "as it left the factory" and there's no wiring "mods" the terminal where the yellow "S" wire connects at the solenoid will be at +12 Volts (nominal) with respect to chassis ground under normal conditions and at -12 Volts (nominal) with respect to chassis ground during cranking.

While cranking, with the red (+) voltmeter probe on the small "R" terminal on the solenoid and the black (-) voltmeter probe on the "S" terminal on the solenoid the meter should read 24 Volts (nominal).

HTH!

This post was edited by wore out on 06/14/2021 at 09:04 am.

 
Back to top
View user's profile
Deeredawg
New User


Joined: 02 May 2021
Posts: 9


Report to Moderator

PostPosted: Mon Jun 14, 2021 6:59 am    Post subject: Re: 3010D 24V starter prblems Reply to specific post Reply with quote

This is super helpful. Thank you!!!
 
Back to top
View user's profile
rvirgil_KS
Tractor Expert


Joined: 07 Jul 2007
Posts: 2013
Location: Northwest Kansas

Report to Moderator

PostPosted: Mon Jun 14, 2021 7:45 am    Post subject: Re: 3010D 24V starter prblems Reply to specific post Reply with quote

Black volt meter probe should be (-) and red probe should be (+)

Brain cramp or clumsy fingers like I sometimes get?
 
Back to top
View user's profile
wore out
Tractor Expert


Joined: 01 Oct 2019
Posts: 2778


Report to Moderator

PostPosted: Mon Jun 14, 2021 8:05 am    Post subject: Re: 3010D 24V starter prblems Reply to specific post Reply with quote

CVPost-rvirgil_KS wrote:
(quoted from post at 08:45:17 06/14/21) Black volt meter probe should be (-) and red probe should be (+)

Brain cramp or clumsy fingers like I sometimes get?


THANKS for the "heads up", rvirgil, I corrected my errors!


And, DANG, I proofread that a dozen times before AND after I posted it!
 
Back to top
View user's profile
Deeredawg
New User


Joined: 02 May 2021
Posts: 9


Report to Moderator

PostPosted: Mon Jun 14, 2021 5:03 pm    Post subject: Re: 3010D 24V starter prblems Reply to specific post Reply with quote

Success!!!!! First, off, thank you so much for helping out. Your guidance brought me right to the problem (although it turned out pretty easy). At normal, the S
terminal to tractor ground was 12V. While cranking, S & R were 0 V. I checked continuity of all wires to starter/solenoid and yellow was open. Dang it. I went
over and found a loose connection on the Park switch (which I swear I checked before) but found both terminals loose. Pushed them down and away we go! I can't
thank you enough and am planning on framing your advice so I don't forget it!
 
Back to top
View user's profile
wore out
Tractor Expert


Joined: 01 Oct 2019
Posts: 2778


Report to Moderator

PostPosted: Mon Jun 14, 2021 9:37 pm    Post subject: Re: 3010D 24V starter prblems Reply to specific post Reply with quote

CVPost-Deeredawg wrote:
(quoted from post at 18:03:01 06/14/21) Success!!!!! First, off, thank you so much for helping out. Your guidance brought me right to the problem (although it turned out pretty easy). At normal, the S
terminal to tractor ground was 12V. While cranking, S & R were 0 V. I checked continuity of all wires to starter/solenoid and yellow was open. Dang it. I went
over and found a loose connection on the Park switch (which I swear I checked before) but found both terminals loose. Pushed them down and away we go! I can't
thank you enough and am planning on framing your advice so I don't forget it!


THANKS for posting back with your success story!
 
Back to top
View user's profile
:   
Post new topic    Yesterday's Tractors Forum Index -> Restoration and Repair Tips All times are GMT - 8 Hours
Page 1 of 1

 
Jump to:  

TRACTOR PARTS TRACTOR MANUALS
We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]

YT Home  |  Forums

Modern View Forum powered by phpBB © 2001, 2005 phpBB Group

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters