Yesterday's Tractor Co.
Shop Now View Cart
   Allis Chalmers Case Farmall IH Ford 9N,2N,8N Ford
   Ferguson John Deere Massey Ferguson Minn. Moline Oliver
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   Traditional YT Forum ViewClassic View   RegisterRegister 
 ProfileProfile    Log inLog in 

Case IH IronGard paint mixing ratio?

Post new topic    
View previous topic :: View next topic  
Author Message

Joined: 03 Jun 2018
Posts: 37

Report to Moderator

PostPosted: Sun Jun 20, 2021 1:06 pm    Post subject: Case IH IronGard paint mixing ratio? Reply to specific post Reply with quote

Im sure this has been asked before but I cant find a definite answer. Im ready to paint my H so I went to my local CaseIH dealer and got some primer, red paint, thinner and hardener. They are all Irongard brand minus the hardener which is valspar but that's all the dealer had. I asked one of the guys there that has painted with it and he said he uses 3oz of hardener and 4oz of thinner per 1 quart of paint. Was wondering if that sounds accurate? Both the primer and paint say to use 8 parts paint to 1 part thinner. However the paint doesnt say anything about the hardener. Just wondering what ratios you guys have used to get good results. Thanks in advance.
Back to top
View user's profile

Joined: 12 Oct 2016
Posts: 135

Report to Moderator

PostPosted: Mon Jun 21, 2021 10:02 am    Post subject: Re: Case IH IronGard paint mixing ratio? Reply to specific post Reply with quote

I use a steel 1/2 cup measuring cup to mix ih paint. 4 loads of paint 2 loads of thinner and 1 of hardener. My paint job looks like this in the end:

Back to top
View user's profile
Post new topic    Yesterday's Tractors Forum Index -> Farmall & International Harvester (IHC) All times are GMT - 8 Hours
Page 1 of 1

Jump to:  

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]

YT Home  |  Forums

Modern View Forum powered by phpBB © 2001, 2005 phpBB Group

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters