Yesterday's Tractor Co.
Shop Now View Cart
   Allis Chalmers Case Farmall IH Ford 9N,2N,8N Ford
   Ferguson John Deere Massey Ferguson Minn. Moline Oliver
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   Traditional YT Forum ViewClassic View   RegisterRegister 
 ProfileProfile    Log inLog in 

Kuhn GMD 700 GII Rebuild

Post new topic    
View previous topic :: View next topic  
Author Message
New User

Joined: 22 Jun 2021
Posts: 1

Report to Moderator

PostPosted: Tue Jun 22, 2021 6:13 am    Post subject: Kuhn GMD 700 GII Rebuild Reply to specific post Reply with quote

Had a bearing go out in the cutter bar and of course, jumped in without paying attention to disc alignment. I have it rebuilt and back together, but how do you time the disc when putting them back in the bar? I know disc 2-6 will be 90 degrees to each other, but the first and second disc spin the same direction, so the first will have an offset compared to the others.
Back to top
View user's profile
Tractor Guru

Joined: 02 Mar 2018
Posts: 4494

Report to Moderator

PostPosted: Tue Jun 22, 2021 8:26 am    Post subject: Re: Kuhn GMD 700 GII Rebuild Reply to specific post Reply with quote

There is a free Operator's manual on line if you don't have one. It shows disc location and rotation which I think might give you the info you need.
Back to top
View user's profile
Post new topic    Yesterday's Tractors Forum Index -> Restoration and Repair Tips All times are GMT - 8 Hours
Page 1 of 1

Jump to:  

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]

YT Home  |  Forums

Modern View Forum powered by phpBB © 2001, 2005 phpBB Group

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters