Yesterday's Tractor Co.
Shop Now View Cart
   Allis Chalmers Case Farmall IH Ford 9N,2N,8N Ford
   Ferguson John Deere Massey Ferguson Minn. Moline Oliver
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   Traditional YT Forum ViewClassic View   RegisterRegister 
 ProfileProfile    Log inLog in 

Walboro carburetor.


 
Post new topic    
View previous topic :: View next topic  
Author Message
Gene Davis (Ga.)
Tractor Expert


Joined: 25 Oct 2003
Posts: 2185


Report to Moderator

PostPosted: Fri Sep 03, 2021 6:03 am    Post subject: Walboro carburetor. Reply to specific post Reply with quote

Hi. I am restoring a old Mott push type 21 cut flail mower with a Clinton engine and have a problem with the carburetor body.After cleaning it and as i was reassembling it the threads stripped out of the body where the main nozzle goes, They were very thin and when I tightened it they pulled out before they tightened. Tried building up with J B weld but that did not hold either. Does anybody have a Walboro LMV, LME or LMG carburetor they would sell.I could get by with just the main body and use my inside parts if necessary. Gene Davis Tennille, Ga.
Email is: gadavis9180@gmail.com xxx ---remove the three x's to send.
 
Back to top
View user's profile
Gene Davis (Ga.)
Tractor Expert


Joined: 25 Oct 2003
Posts: 2185


Report to Moderator

PostPosted: Sat Sep 04, 2021 6:25 am    Post subject: Re: Walboro carburetor. Reply to specific post Reply with quote

letters and numbers on the carburetor are: LMG and on a raised boss above this are these numbers: 115. Thanks for looking. gene Davis
 
Back to top
View user's profile
Richard G.
Tractor Guru


Joined: 08 Oct 2000
Posts: 15344
Location: Oakway, SC

Report to Moderator

PostPosted: Sun Sep 05, 2021 3:57 am    Post subject: Re: Walboro carburetor. Reply to specific post Reply with quote

Gene, years ago I repaired the threads on a Cub main jet hole in the carb.
They are very fine threads also.
Old auto parts store had an epoxy thread repair kit that worked very well.
That Cub is still going.
It has been too long ago for me to remember the name of the stuff I used.
 
Back to top
View user's profile
Billy Shafer
Tractor Guru


Joined: 24 Apr 2009
Posts: 10077


Report to Moderator

PostPosted: Mon Sep 06, 2021 4:08 am    Post subject: Re: Walboro carburetor. Reply to specific post Reply with quote

You could try over at Smokstak.
 
Back to top
View user's profile
tractorguy2
Tractor Guru


Joined: 24 May 2014
Posts: 3989


Report to Moderator

PostPosted: Tue Sep 07, 2021 5:23 pm    Post subject: Re: Walboro carburetor. Reply to specific post Reply with quote

Ive never tried it but loctite makes a thread repair product.
 
Back to top
View user's profile
Richard G.
Tractor Guru


Joined: 08 Oct 2000
Posts: 15344
Location: Oakway, SC

Report to Moderator

PostPosted: Wed Sep 08, 2021 5:16 am    Post subject: Re: Walboro carburetor. Reply to specific post Reply with quote

I believe it was Loctite.
 
Back to top
View user's profile
:   
Post new topic    Yesterday's Tractors Forum Index -> Stationary Engines All times are GMT - 8 Hours
Page 1 of 1

 
Jump to:  

TRACTOR PARTS TRACTOR MANUALS
We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]

YT Home  |  Forums

Modern View Forum powered by phpBB © 2001, 2005 phpBB Group

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters