Yesterday's Tractor Co.
Shop Now View Cart
   Allis Chalmers Case Farmall IH Ford 9N,2N,8N Ford
   Ferguson John Deere Massey Ferguson Minn. Moline Oliver
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   Traditional YT Forum ViewClassic View   RegisterRegister 
 ProfileProfile    Log inLog in 

An update on the TO20,,,,,


 
Post new topic    
View previous topic :: View next topic  
Author Message
Buggyboy
Regular


Joined: 03 Jun 2015
Posts: 98


Report to Moderator

PostPosted: Tue Sep 14, 2021 6:49 pm    Post subject: An update on the TO20,,,,, Reply to specific post Reply with quote

Howdy Folks,,,, I am feeling like I may have finally got to where I been wanting to be for a long time with My Ferguson TO20. The tractor I picked up over the past weekend has an engine that is sure looking like a keeper!! The PO assured me the engine was in great running condition except for the bad oil leak out the rear main.
I finally got to where I could get a good close look up into the bottom of the sleeve web area and I am overjoyed as there is NOT any evidence of a crack in any of the webs between the cylinders,,,!!!! YEA, Yea, Yea,,,!!! In fact, the cooling system of engine was full of antifreeze when I removed the radiator and is very clean inside, more Yeas,,!!
As I reported earlier, I thought the rear main had shifted and there was an obvious misalignment of it to the block,,? The PO had removed the two rear main bolts (??) and the rear main itself had shifted inwards. I went ahead and removed the rear main so I can repack the two sides of the rear main to the block and I'll be ready to install the oil filter and close up the oil pan, hot wire the coil and put a spark in it to hear it run, before I bolt the two halves together,,,,,wish me luck, fellows,,,!!!!
 
Back to top
View user's profile
Bruce(OR)
Tractor Guru


Joined: 10 Apr 2007
Posts: 3793


Report to Moderator

PostPosted: Wed Sep 15, 2021 4:12 pm    Post subject: Re: An update on the TO20,,,,, Reply to specific post Reply with quote

Have fun!
 
Back to top
View user's profile
Buggyboy
Regular


Joined: 03 Jun 2015
Posts: 98


Report to Moderator

PostPosted: Wed Sep 15, 2021 6:06 pm    Post subject: Re: An update on the TO20,,,,, Reply to specific post Reply with quote


THANK YOU, Bruce,,,,, Wink
 
Back to top
View user's profile
Buggyboy
Regular


Joined: 03 Jun 2015
Posts: 98


Report to Moderator

PostPosted: Wed Sep 15, 2021 6:10 pm    Post subject: Re: An update on the TO20,,,,, Reply to specific post Reply with quote


How does one get to talk to CS when trying to order pARTS??? I called this afternoon and got put on "HOLD" for 25 minutes!! I hung up figuring they forgot me and tried again bout an hour later,,got put on HOLD again and after 12 minutes I hung up again.
anybody got some kind words,,,,,,?
 
Back to top
View user's profile
Jim L WA
Tractor Expert


Joined: 17 Jun 2010
Posts: 1502


Report to Moderator

PostPosted: Thu Sep 16, 2021 8:32 am    Post subject: Re: An update on the TO20,,,,, Reply to specific post Reply with quote

Hi Buggyboy, You are not alone with trying reach these people by telephone. "All our agents are busy" translates to ONE agent I think. Can you find the parts you need in the parts search?
 
Back to top
View user's profile
Buggyboy
Regular


Joined: 03 Jun 2015
Posts: 98


Report to Moderator

PostPosted: Thu Sep 16, 2021 11:12 am    Post subject: Re: An update on the TO20,,,,, Reply to specific post Reply with quote

Jim L WA wrote:
(quoted from post at 09:32:46 09/16/21) Hi Buggyboy, You are not alone with trying reach these people by telephone. "All our agents are busy" translates to ONE agent I think. Can you find the parts you need in the parts search?


HI Jim,,well, I finally managed to get hooked up with the one parts person (LOL) and she was quite friendly,,!! I didn't tell her what I thought, tho) I called EARLY this morning and only had to wait for 27 minutes. Got what I needed except for the spring under the oil filter as it is missing in action from when I picked up the tractor,,,WAY Over yonder,!! I'm sure hoping I can fanagle one from a member that has an extra. as I read some where that you should replace the spring every oil change,,,,,"every change???" Many THANKS for your help and concern, Jim.
 
Back to top
View user's profile
Buggyboy
Regular


Joined: 03 Jun 2015
Posts: 98


Report to Moderator

PostPosted: Fri Sep 17, 2021 12:55 am    Post subject: Re: An update on the TO20,,,,, Reply to specific post Reply with quote


Well,,I ain't having any luck finding a drawing on the necessary parts for the oil filter, screen, housing, spring for the TO20. The download I got from here does not show a "spring"under the filter as described in the shop manual I downloaded,,,??
All I have is a Can, and a screen,,,,
Can anybody help on this,,??
 
Back to top
View user's profile
:   
Post new topic    Yesterday's Tractors Forum Index -> Harry Ferguson All times are GMT - 8 Hours
Page 1 of 1

 
Jump to:  

TRACTOR PARTS TRACTOR MANUALS
We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]

YT Home  |  Forums

Modern View Forum powered by phpBB © 2001, 2005 phpBB Group

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters