Yesterday's Tractor Co.
Shop Now View Cart
   Allis Chalmers Case Farmall IH Ford 9N,2N,8N Ford
   Ferguson John Deere Massey Ferguson Minn. Moline Oliver
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   Traditional YT Forum ViewClassic View   RegisterRegister 
 ProfileProfile    Log inLog in 

7040


 
Post new topic    
View previous topic :: View next topic  
Author Message
danzangus
Regular


Joined: 09 Mar 2019
Posts: 27


Report to Moderator

PostPosted: Wed Jun 22, 2022 1:27 pm    Post subject: 7040 Reply to specific post Reply with quote

One last question about my 7040. I have ordered all the parts for rebuilding the torque limiter. I just got the flywheel resurfaced and I will be putting on the new ring gear.The machinist recommended replacing what -looks like a pressed on bushing or ring on non machined side ,Approx. 5 inches accross. I can't find it in the manual and not sure what the correct name is for this part. Also what is the best way to remove the old.warn out ring. I had no problem removing the ring gear and will try heating the new one in the oven to expand it.Sounds a little crazy but I have seen it done.So basically I just need a part name. Thanks
 
Back to top
View user's profile
DrAllis
Tractor Expert


Joined: 18 Jan 2015
Posts: 1785


Report to Moderator

PostPosted: Wed Jun 22, 2022 3:06 pm    Post subject: Re: 7040 Reply to specific post Reply with quote

The wear sleeve pressed on the flywheel for the rear crank seal??......74029556 from AGCO.
 
Back to top
View user's profile
:   
Post new topic    Yesterday's Tractors Forum Index -> Allis Chalmers All times are GMT - 8 Hours
Page 1 of 1

 
Jump to:  

TRACTOR PARTS TRACTOR MANUALS
We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]

YT Home  |  Forums

Modern View Forum powered by phpBB © 2001, 2005 phpBB Group

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters