PartsASAP Logo Company Logo Auction Link (800) 853-2651

Shop Now

   Allis Chalmers Case Farmall IH Ford 9N,2N,8N Ford
   Ferguson John Deere Massey Ferguson Minn. Moline Oliver
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   Traditional YT Forum ViewClassic View   RegisterRegister 
 ProfileProfile    Log inLog in 

VAC CASE PISTON RINGS


 
Post new topic    
View previous topic :: View next topic  
Author Message
Kenny Bill
New User


Joined: 13 May 2010
Posts: 13


Report to Moderator
PostPosted: Mon Sep 18, 2023 1:56 pm    Post subject: VAC CASE PISTON RINGS Reply to specific post Reply with quote
I am installing piston rings.. Service manual says to look for a dot or a marking top to install rings right side up. Rings that I have are not marked at all. Can anyone help in determining which side is up.
 
Back to top
View user's profile
r.w.b.
Tractor Expert


Joined: 04 Jul 2016
Posts: 2565


Report to Moderator
PostPosted: Tue Sep 19, 2023 2:24 am    Post subject: Re: VAC CASE PISTON RINGS Reply to specific post Reply with quote
take em back,ask for instruction sheet for the rings.
 
Back to top
View user's profile
mEl
Tractor Guru


Joined: 28 Sep 1998
Posts: 6178


Report to Moderator
PostPosted: Tue Sep 19, 2023 3:57 am    Post subject: Re: VAC CASE PISTON RINGS Reply to specific post Reply with quote
CVPost-Kenny Bill wrote:
(quoted from post at 17:56:25 09/18/23) I am installing piston rings.. Service manual says to look for a dot or a marking top to install rings right side up. Rings that I have are not marked at all. Can anyone help in determining which side is up.


As a rule rings not marked are ok either direction, BUT, inspect the rings carefully on the inner and outer ring edges. Rings with a bevel or cut on the inside edge go inside edge uo, if the is a groove cut on one side of the outer ring that would go down.
 
Back to top
View user's profile
:   
Post new topic    Yesterday's Tractors Forum Index -> Case and David Brown All times are GMT - 8 Hours
Page 1 of 1

 
Jump to:  

TRACTOR PARTS TRACTOR MANUALS
We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]

YT Home  |  Forums

Modern View Forum powered by phpBB © 2001, 2005 phpBB Group

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters