PartsASAP LogoCompany Logo Auction Link (800) 853-2651

Shop Now

   Allis Chalmers Case Farmall IH Ford 9N,2N,8N Ford
   Ferguson John Deere Massey Ferguson Minn. Moline Oliver
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   Traditional YT Forum ViewClassic View   RegisterRegister 
 ProfileProfile    Log inLog in 

F2 Gleaner grease zerks


 
Post new topic    
View previous topic :: View next topic  
Author Message
pea_grower
Regular


Joined: 28 Nov 2010
Posts: 222
Location: SW Oklahoma

Report to Moderator
PostPosted: Mon Nov 13, 2023 4:19 pm    Post subject: F2 Gleaner grease zerks Reply to specific post Reply with quote
On the separator clutch side, the variable speed sheeve (for cylinder speed) has a grease zerk behind the sprocket. Does that one grease all the bearings for that variable? Cant feel one on the back sheeve to grease that bearing, and there isnt much room anyway.
 
Back to top
View user's profile
Doug Wi
Regular


Joined: 01 Nov 2010
Posts: 440


Report to Moderator
PostPosted: Mon Nov 13, 2023 6:39 pm    Post subject: Re: F2 Gleaner grease zerks Reply to specific post Reply with quote
I think that one fitting greases the variable speed bearings. Book says to grease till grease comes out a small hole on the same hub as the fitting. Just got mine fixed today. Had to get a used hub
from the bone yard cause the inside had worn enough that the snap ring groove to hold the bearing in place wasn't deep enough to hold anymore. Took well over 1/2 tube of grease to fill it. 2nd time it
has failed
 
Back to top
View user's profile
Skyhighballoon(MO)
Long Time User


Joined: 06 Jul 2007
Posts: 673


Report to Moderator
PostPosted: Thu Nov 16, 2023 8:24 am    Post subject: Re: F2 Gleaner grease zerks Reply to specific post Reply with quote
There is only one grease zerk on my F2's on the sprocket/sheave with chain that runs up to the cab that you hand crank for the cylinder speed. That's what the parts book shows too.
 
Back to top
View user's profile
:   
Post new topic    Yesterday's Tractors Forum Index -> Combines and Harvesters All times are GMT - 8 Hours
Page 1 of 1

 
Jump to:  

TRACTOR PARTS TRACTOR MANUALS
We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]

YT Home  |  Forums

Modern View Forum powered by phpBB © 2001, 2005 phpBB Group

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters