PartsASAP LogoCompany Logo Auction Link (800) 853-2651

Shop Now

   Allis Chalmers Case Farmall IH Ford 9N,2N,8N Ford
   Ferguson John Deere Massey Ferguson Minn. Moline Oliver
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   Traditional YT Forum ViewClassic View   RegisterRegister 
 ProfileProfile    Log inLog in 

Oliver 1655 Over/Under Input Shaft Wear

Post new topic    
View previous topic :: View next topic  
Author Message
New User

Joined: 20 Nov 2023
Posts: 2

Report to Moderator

PostPosted: Mon Nov 20, 2023 1:48 pm    Post subject: Oliver 1655 Over/Under Input Shaft Wear Reply to specific post Reply with quote

I am currently redoing an Oliver 1655 that had a cracked bell housing. Once we got everything pulled apart we noticed the input splines on the input for the over/under, as well as the clutch had wear on them. I was curiuos if anyone else has seen anything like this or if anyone had a reccomendation on replacing the shaft or leaving well enough alone? I was planning on installing a new clutch and bearings already. Any info would be greatly appreciated!
Back to top
View user's profile
Harry in Ky
Long Time User

Joined: 08 Jan 2012
Posts: 519

Report to Moderator

PostPosted: Tue Nov 21, 2023 6:51 am    Post subject: Re: Oliver 1655 Over/Under Input Shaft Wear Reply to specific post Reply with quote

Unless it's ready to strip out completely, I'd leave it alone. It's taken fifty years to get this way, how many more years are you expecting to get?
Back to top
View user's profile
Post new topic    Yesterday's Tractors Forum Index -> Restoration and Repair Tips All times are GMT - 8 Hours
Page 1 of 1

Jump to:  

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]

YT Home  |  Forums

Modern View Forum powered by phpBB © 2001, 2005 phpBB Group

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters