Yesterday's Tractor Co.
Shop Now View Cart
   Allis Chalmers Case Farmall IH Ford 9N,2N,8N Ford
   Ferguson John Deere Massey Ferguson Minn. Moline Oliver
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   Traditional YT Forum ViewClassic View   RegisterRegister 
 ProfileProfile    Log inLog in 

front seal in trans


 
Post new topic    
View previous topic :: View next topic  
Author Message
michael in tenn
Guest






Report to Moderator

PostPosted: Thu May 24, 2007 4:28 am    Post subject: front seal in trans Reply to specific post Reply with quote

I have a T020 51 model. In process of restoreing it. I know the front seal is leaking in trans, when i lower the front end it will run out overnight and be some leakage on the bell housing. Im gona split the tractor to put rear seal in motor anyway and while i have it split i need to adress the trans leakage. I have allready removed the stearing box and have noticed a long tube like shaft that is conected to the clutch and the wet side of the trans. I am ASSUMING that the seal that leaks is gona be at the end of the long shaft like tube at the wet side of the trans. What my question is, is this a hard task to do or is it a rather simple job? I have all the manuals on the tractor but it does not go into great detail. Is there anything i need to watch for when doing this job? Where could i find a seal for this? I would like some input on this from you fergie guys, thanks mike.

 
Back to top
John(UK)
Guest






Report to Moderator

PostPosted: Thu May 24, 2007 7:45 am    Post subject: Re: front seal in trans Reply to specific post Reply with quote

Nothing difficult about it, just undo the four setscrews and the "tube" should come off although sometimes they are tight. There was no need to remove the steering box to do this.

 
Back to top
:   
Post new topic    Yesterday's Tractors Forum Index -> Harry Ferguson All times are GMT - 8 Hours
Page 1 of 1

 
Jump to:  

TRACTOR PARTS TRACTOR MANUALS
Fast Shipping!  Most of our stocked parts ship within 24 hours (M-Th). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a company you can trust and have generous return policies. Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ About Us ]

YT Home  |  Forums

Modern View Forum powered by phpBB © 2001, 2005 phpBB Group

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters