Yesterday's Tractor Co.
Shop Now View Cart
   Allis Chalmers Case Farmall IH Ford 9N,2N,8N Ford
   Ferguson John Deere Massey Ferguson Minn. Moline Oliver
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   Traditional YT Forum ViewClassic View   RegisterRegister 
 ProfileProfile    Log inLog in 

JCB 214 series 3 transmission 1998

Post new topic    
View previous topic :: View next topic  
Author Message
Bob Olson

Report to Moderator

PostPosted: Tue May 01, 2007 6:56 pm    Post subject: JCB 214 series 3 transmission 1998 Reply to specific post Reply with quote

Looking for anyone who has had a overheating and shift problem .
After about a hour of operation the transmission will not shift and
feels as the transmission is locking up.
The transmission fluid has been changed and filter replaced but
seems to overheat still.
I also notice transmission fluid coming out the trans fluid fill.
Please help.

Back to top

Report to Moderator

PostPosted: Tue May 01, 2007 11:24 pm    Post subject: Re: JCB 214 series 3 transmission 1998 Reply to specific post Reply with quote

Sounds to me as if the oil pressure is going low as the machine warms up,the cooler for the transmission is in front of the rad,it and the rad need to be clean,look to see that the fan is intact,has no broken blades,the belt is not slipping,the trans fluid is checked with the engine on low idle,there is a washable suction strainer for the trans fluid,its under a oval plate near the spin on filter,there is a quick break test point there as well,have a look at the strainer and it will be a good indicator of what going on inside,if the strainer is not blocked put it back and have the pressure tested,you should find out what's wrong rather than use it because if the pressure is low and not engaging the clutches properly they will be slipping and that will cause excessive wear,the pump may need replacing.

Back to top
Post new topic    Yesterday's Tractors Forum Index -> Crawlers, Dozers, Loaders and Backhoes All times are GMT - 8 Hours
Page 1 of 1

Jump to:  

Fast Shipping!  Most of our stocked parts ship within 24 hours (M-Th). We have the parts you need to repair your tractor - the right parts. Our fast shipping, low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]

YT Home  |  Forums

Modern View Forum powered by phpBB © 2001, 2005 phpBB Group

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters