Yesterday's Tractor Co.
Shop Now View Cart
   Allis Chalmers Case Farmall IH Ford 9N,2N,8N Ford
   Ferguson John Deere Massey Ferguson Minn. Moline Oliver
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   Traditional YT Forum ViewClassic View   RegisterRegister 
 ProfileProfile    Log inLog in 

drag link


 
Post new topic    
View previous topic :: View next topic  
Author Message
Anonymous
Guest






Report to Moderator

PostPosted: Sun Jun 17, 2007 8:00 am    Post subject: drag link Reply to specific post Reply with quote

I am going to replace the right front drag link on my 49 8n. Just wondering what people do to insure that you get the new one back to the same location. Can you measure off a reference point on the tube and is it critical to get the exact position the old one was in. I'm assuming this would affect the alignment.
 
Back to top
Anonymous
Guest






Report to Moderator

PostPosted: Sun Jun 17, 2007 9:27 am    Post subject: Re: drag link Reply to specific post Reply with quote

Some Ford tractors have a factory reference mark on the steering arms, arms that attach to the spindle, and the front axle. This mark is made with a chisel. If your tractor does not have these you can easily make your own. If there is slack in the drag link ends you may want to slightly move the steering wheel find a “center point” before making your marks. One of the service manuals I have gives this information.
 
Back to top
:   
Post new topic    Yesterday's Tractors Forum Index -> Ford 9N, 2N, 8N All times are GMT - 8 Hours
Page 1 of 1

 
Jump to:  

TRACTOR PARTS TRACTOR MANUALS
Fast Shipping!  Most of our stocked parts ship within 24 hours (M-Th). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a company you can trust and have generous return policies. Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ About Us ]

YT Home  |  Forums

Modern View Forum powered by phpBB © 2001, 2005 phpBB Group

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters