Yesterday's Tractor Co.
Shop Now View Cart
   Allis Chalmers Case Farmall IH Ford 9N,2N,8N Ford
   Ferguson John Deere Massey Ferguson Minn. Moline Oliver
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   Traditional YT Forum ViewClassic View   RegisterRegister 
 ProfileProfile    Log inLog in 

Attn: Mel or Casenutty

Post new topic    
View previous topic :: View next topic  
Author Message
Jonathan Dooley
New User

Joined: 10 Jul 2009
Posts: 3

Report to Moderator

PostPosted: Wed Oct 30, 2013 2:18 pm    Post subject: Attn: Mel or Casenutty Reply to specific post Reply with quote

My friend, who has no internet access, suggested I try to get your attentions on this question, thanks:

I have been helping a friend rebuild his 480B transaxle assembly and we have the following issue: we have it about 95% back together and discovered that we didn"t install the wear sleeve on the back end of the mainshaft before installing the seal carrier in the front end of the differential case.
Question; what is the least amount of teardown that could be reasonably done to remove that carrier so that the wear sleeve could be installed?
It looks to me like the differential side gears could be removed with the carrier plates, so the seals would not be damaged, and this would allow the ring gear to drop low enough or flop sideways enough to let the seal carrier to get past it. Let me know if this is not so or if there is an even easier way to do it.
On a related note, the needle bearing and seal in the back-end of that seal carrier seem to be sized for an 1-1/4" shaft but the PTO shaft is 1" at that section, what"s up with that?
Please have a little sympathy on me since this tractor was received in an improper condition, i.e. the tractor came with PTO yet that housing was not even installed causing all sorts of other issues as well.
Thanks for any help you can give on this matter.
Back to top
View user's profile
Post new topic    Yesterday's Tractors Forum Index -> Case and David Brown All times are GMT - 8 Hours
Page 1 of 1

Jump to:  

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]

YT Home  |  Forums

Modern View Forum powered by phpBB © 2001, 2005 phpBB Group

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters