Yesterday's Tractor Co.
Shop Now View Cart
   Allis Chalmers Case Farmall IH Ford 9N,2N,8N Ford
   Ferguson John Deere Massey Ferguson Minn. Moline Oliver
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   Traditional YT Forum ViewClassic View   RegisterRegister 
 ProfileProfile    Log inLog in 

which 282 is the better one

Post new topic    
View previous topic :: View next topic  
Author Message
Tractor Expert

Joined: 05 Feb 2015
Posts: 3230

Report to Moderator

PostPosted: Tue Jan 02, 2018 3:07 pm    Post subject: which 282 is the better one Reply to specific post Reply with quote

Dieseltech, or whoever ,which way is the best way for those sleeve's to be held in the block, i never owned or worked on one, and which way did the wrist pins get bigger , or smaller the more they built?
Back to top
View user's profile
Tractor Guru

Joined: 29 Feb 2012
Posts: 6184
Location: Indiana

Report to Moderator

PostPosted: Tue Jan 02, 2018 4:41 pm    Post subject: Re: which 282 is the better one Reply to specific post Reply with quote

The very first diesels used the smaller gas sized wrist pins in 1958, think it was 1959 when diesel pin size was increased. SN 71778 and up blocks used the heavy press fit cylinder sleeves, early engines used hand slip fit sleeves. Early sleeves had a wide flange the head gasket sealed and held down the sleeves. Heavy press/puller equipment is needed to remove/install the late sleeve. My 560 has the late block as it had an IH short block installed years ago.
Back to top
View user's profile
Display posts from previous:   
Post new topic    Yesterday's Tractors Forum Index -> Farmall & International Harvester (IHC) All times are GMT - 8 Hours
Page 1 of 1

Jump to:  

Fast Shipping!  Most of our stocked parts ship within 24 hours (M-Th). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a company you can trust and have generous return policies. Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ About Us ]

YT Home  |  Forums

Modern View Forum powered by phpBB © 2001, 2005 phpBB Group

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters