Yesterday's Tractor Co.
Shop Now View Cart
   Allis Chalmers Case Farmall IH Ford 9N,2N,8N Ford
   Ferguson John Deere Massey Ferguson Minn. Moline Oliver
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   Traditional YT Forum ViewClassic View   RegisterRegister 
 ProfileProfile    Log inLog in 

70D flywheel


 
Post new topic    
View previous topic :: View next topic  
Author Message
plowhand
Regular


Joined: 04 Jan 2011
Posts: 96


Report to Moderator

PostPosted: Sat Jan 13, 2018 4:55 pm    Post subject: 70D flywheel Reply to specific post Reply with quote

How does this flywheel look?


 
Back to top
View user's profile
Mike M
Tractor Guru


Joined: 31 Mar 1998
Posts: 26648


Report to Moderator

PostPosted: Sun Jan 14, 2018 6:37 am    Post subject: Re: 70D flywheel Reply to specific post Reply with quote

Looks "normal" from here. But hard to see if it has any cracks in it with a picture.
 
Back to top
View user's profile
Dan in Ohio
Long Time User


Joined: 27 Apr 2008
Posts: 1235


Report to Moderator

PostPosted: Sun Jan 14, 2018 8:33 am    Post subject: Re: 70D flywheel Reply to specific post Reply with quote

Like one that someone has tried to tighten using a new grade 8 nut on an original (already stretched) bolt with an oil stain on the ground. Could be a normal flywheel on a 70D that is just marking it's spot in the shed as some of mine do, hard to say just looking.
 
Back to top
View user's profile
Blksmok
Regular


Joined: 25 Nov 2012
Posts: 291


Report to Moderator

PostPosted: Sun Jan 14, 2018 11:14 am    Post subject: Re: 70D flywheel Reply to specific post Reply with quote

Outside of obvious cracks, you can not tell the condition just by looking. The new nuts indicate there may have been a problem in the past. Best test is to loosen the bolts and check to see if there is ANY rotational movement of the flywheel on the crankshaft. If there is both the flywheel and crankshaft splines are worn.
 
Back to top
View user's profile
buickanddeere
Tractor Guru


Joined: 31 May 2003
Posts: 32597
Location: in front of computer

Report to Moderator

PostPosted: Sun Jan 14, 2018 5:02 pm    Post subject: Re: 70D flywheel Reply to specific post Reply with quote


One new nut on an old bolt could be indications that some cheapskate was cutting corners during repair and service . A pair of new bolts, nuts and washers are not expensive or difficult to find .
 
Back to top
View user's profile
:   
Post new topic    Yesterday's Tractors Forum Index -> John Deere All times are GMT - 8 Hours
Page 1 of 1

 
Jump to:  

TRACTOR PARTS TRACTOR MANUALS
Fast Shipping!  Most of our stocked parts ship within 24 hours (M-Th). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a company you can trust and have generous return policies. Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ About Us ]

YT Home  |  Forums

Modern View Forum powered by phpBB © 2001, 2005 phpBB Group

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters