Yesterday's Tractor Co.
Shop Now View Cart
   Allis Chalmers Case Farmall IH Ford 9N,2N,8N Ford
   Ferguson John Deere Massey Ferguson Minn. Moline Oliver
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   Traditional YT Forum ViewClassic View   RegisterRegister 
 ProfileProfile    Log inLog in 

MF 10 baler


 
Post new topic    
View previous topic :: View next topic  
Author Message
Sureshot312
New User


Joined: 01 Aug 2018
Posts: 1


Report to Moderator

PostPosted: Wed Aug 01, 2018 6:53 am    Post subject: MF 10 baler Reply to specific post Reply with quote

I have the inside knotter that will not let go of the knot after it has tied and I am tired of getting off the tractor to slide the knot off the finger after it ties every bale. Can anyone help me figure out how to get the knotter to release the knot. The other side works just fine never any problems. I have put a new knotter on that side and still same problem. I use sisil twine.
 
Back to top
View user's profile
jturn36178
Regular


Joined: 10 Feb 2017
Posts: 60


Report to Moderator

PostPosted: Wed Aug 01, 2018 7:22 am    Post subject: Re: MF 10 baler Reply to specific post Reply with quote

Stripper arm is bent or the roller has worn out.
Common problem to bend an arm.
Not easy to buy (outrageous) even if you can find a new one.
Very very difficult to bend back to correct without messing up knife clearances etc. Darned near impossible but can be done with a lot of patience.
My Dad was MF dealer for over 40 someodd years. So seen a lot of bent ones.
 
Back to top
View user's profile
Display posts from previous:   
Post new topic    Yesterday's Tractors Forum Index -> Harry Ferguson All times are GMT - 8 Hours
Page 1 of 1

 
Jump to:  

TRACTOR PARTS TRACTOR MANUALS
Fast Shipping!  Most of our stocked parts ship within 24 hours (M-Th). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a company you can trust and have generous return policies. Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ About Us ]

YT Home  |  Forums

Modern View Forum powered by phpBB © 2001, 2005 phpBB Group

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters