Yesterday's Tractor Co.
Shop Now View Cart
   Allis Chalmers Case Farmall IH Ford 9N,2N,8N Ford
   Ferguson John Deere Massey Ferguson Minn. Moline Oliver
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   Traditional YT Forum ViewClassic View   RegisterRegister 
 ProfileProfile    Log inLog in 

Farmall C

Post new topic    
View previous topic :: View next topic  
Author Message
New User

Joined: 27 Sep 2014
Posts: 19

Report to Moderator

PostPosted: Thu Sep 20, 2018 1:00 pm    Post subject: Farmall C Reply to specific post Reply with quote

When I bought the tractor it had a coil spring that is anchored near the front of the engine and the other end is attached to the carburetor where the governor rod connects to carb. When I removed it the tractor ran so rough, I had to hook it back up.

I was at a tractor show 2 years ago and I saw the same setup on another Farmall C.

Is this a cobbled-up solution to compensate for a governor problem?
Back to top
View user's profile
Rick Remmert

Joined: 08 Apr 2011
Posts: 491

Report to Moderator

PostPosted: Thu Sep 20, 2018 2:58 pm    Post subject: Re: Farmall C Reply to specific post Reply with quote

Yes it is. Probably did it to keep from having to open up the governor case and fix what was wrong. The other guys and girls on here may have seen this before. I would not run my Super C with that kind of setup.
Back to top
View user's profile
Post new topic    Yesterday's Tractors Forum Index -> Farmall & International Harvester (IHC) All times are GMT - 8 Hours
Page 1 of 1

Jump to:  

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]

YT Home  |  Forums

Modern View Forum powered by phpBB © 2001, 2005 phpBB Group

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters