Yesterday's Tractor Co.
Shop Now View Cart
   Allis Chalmers Case Farmall IH Ford 9N,2N,8N Ford
   Ferguson John Deere Massey Ferguson Minn. Moline Oliver
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   Traditional YT Forum ViewClassic View   RegisterRegister 
 ProfileProfile    Log inLog in 

John Deere 6620 auger under straw walkers


 
Post new topic    
View previous topic :: View next topic  
Author Message
andy r
Regular


Joined: 07 Jul 2013
Posts: 442


Report to Moderator

PostPosted: Wed Sep 19, 2018 5:58 pm    Post subject: John Deere 6620 auger under straw walkers Reply to specific post Reply with quote

This is a John Deere 6620 sidehill. I had noticed a slight "thump, thump, thump" from the rear end. I took the left wooden block off of one of the five auger shafts under the straw walkers and found that the hollow tubular shaft was only half there. So, when the tubular shaft turns it is sort of dropping up and down in the wood block. I think the wood block was sort of worn and allowed the hollow shaft to be cut on the sheet metal that holds the wooden bearings. So, I have some questions. Does the pan that the augers sit in hinge up front drop down in the rear? I really doubt that it does. Can the augers be pulled out without taking the rear hood or other side sheets off??? If it ends up being a time consuming project I am just going to put a tight fitting shaft into the auger tube, weld it, and make a new wooden block with a hole the size of the new inserted shaft. Any ideas on the proper removal and repair are appreciated. Thank you.
 
Back to top
View user's profile
4520BW
Tractor Guru


Joined: 05 Aug 2015
Posts: 3916


Report to Moderator

PostPosted: Wed Sep 19, 2018 6:20 pm    Post subject: Re: John Deere 6620 auger under straw walkers Reply to specific post Reply with quote

I have have always taken the rear hood off to replace the shoe augers. Never tried it any other way.
 
Back to top
View user's profile
JohnS1970
Regular


Joined: 11 Nov 2011
Posts: 131


Report to Moderator

PostPosted: Fri Sep 21, 2018 7:12 pm    Post subject: Re: John Deere 6620 auger under straw walkers Reply to specific post Reply with quote

Remove the back panel, the auger trough will drop down "hinged" if you remove the back bolts. Remove the rear wood block bearing, the drive gear and bearing from the front under the feeder house and screw the auger one way and then the other through the slotted hole at the rear.
 
Back to top
View user's profile
JD Seller
Tractor Guru


Joined: 11 Mar 2009
Posts: 17636


Report to Moderator

PostPosted: Sat Sep 22, 2018 2:47 pm    Post subject: Re: John Deere 6620 auger under straw walkers Reply to specific post Reply with quote

Just remove the panel above the straw chopper on the rear hood. With a cordless impact it takes me less than ten minutes by myself. Then I do not drop the auger pan either just remove the drive gear and bearing on the front. Then just reach up under the straw walkers and take the bolts out of the rear wooden block. Screw the auger out and then tip it down an out the lower panel hole you took off.

I just changed two of mine and I did them both after lunch an did evening chores at 5 PM.
 
Back to top
View user's profile
Display posts from previous:   
Post new topic    Yesterday's Tractors Forum Index -> Combines and Harvesters All times are GMT - 8 Hours
Page 1 of 1

 
Jump to:  

TRACTOR PARTS TRACTOR MANUALS
Fast Shipping!  Most of our stocked parts ship within 24 hours (M-Th). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a company you can trust and have generous return policies. Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ About Us ]

YT Home  |  Forums

Modern View Forum powered by phpBB © 2001, 2005 phpBB Group

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters