Yesterday's Tractor Co.
Shop Now View Cart
   Allis Chalmers Case Farmall IH Ford 9N,2N,8N Ford
   Ferguson John Deere Massey Ferguson Minn. Moline Oliver
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   Traditional YT Forum ViewClassic View   RegisterRegister 
 ProfileProfile    Log inLog in 

Oliver 60 bell housing question?

Post new topic    
View previous topic :: View next topic  
Author Message

Joined: 05 Jan 2010
Posts: 421

Report to Moderator

PostPosted: Mon Oct 01, 2018 4:05 pm    Post subject: Oliver 60 bell housing question? Reply to specific post Reply with quote

Could some one tell me the diameter of the clutch rod hole in the bell housing. Some one has welded a washer on the outside of mine and didn't get it centered and it pushes to one side on the throw out bearing carrier. The hole in the washer they used is only slightly larger than the rod. Thanks for your help.
Back to top
View user's profile

Joined: 23 Oct 2014
Posts: 48

Report to Moderator

PostPosted: Wed Oct 03, 2018 7:50 pm    Post subject: Re: Oliver 60 bell housing question? Reply to specific post Reply with quote

Send me an email and I will get you the measurements. I have a few of those housing around here. Kevin
Back to top
View user's profile
Post new topic    Yesterday's Tractors Forum Index -> Oliver, Cletrac, Coop and Cockshutt All times are GMT - 8 Hours
Page 1 of 1

Jump to:  

Fast Shipping!  Most of our stocked parts ship within 24 hours (M-Th). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a company you can trust and have generous return policies. Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ About Us ]

YT Home  |  Forums

Modern View Forum powered by phpBB © 2001, 2005 phpBB Group

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters