Case 930 models question?

[Robsolhayground]

I'm looking at a diesel 930 with humungous rear fenders like a 1030,3 point,dual hyd and pto with adjustable wide front. I'm just curious what model number or variation of the 930 is it? Does not have tie rods out front like others I've been around. Thanks for the help
 

[Jeff From WI.]

We always called them a Western ModelI think that most of them were bare backs.

I Loved the looks of them old girls :)

Jeff
 

[Paul A Young]

932

 

[Case Nutty 1660]

They are only nicknamed Western's or std if they are a 8 speed, with the set back axle and big fenders, the big fenders could be ordered on the GP models also, Case called them a "Special Model" like any other 30 series other than the 6 speed 930's 3pt was always a option just like hyd and pto was, lots of them ordered as a "Special" was ordered with 3pt just like mine was, all depends on how they were ordered, this is a common mistake many make thinking they were only available bareback, 70 series, 90,94 and 96 series 3 pt was also a option
cnt











this was the last 30 series we ordered in and was not sold until early 1971
 

[pjhulbert]

I have a 6spd with the same cab as pictured. I am missing the rear window, frame and latches. I would like to find one to make the cab complete.
thanks,
Jerry
 

[Robsolhayground]

. I went and looked at it today,and I'm wondering how to adjust pto brake? It's a model 932,runs super good,but has gotta have brakes. What's the S position for on the dash shifter?
 

[Ande]

Here is a "931" that was shown in the Case literature

 

[RGMartin]

[Adirondack case guy]

Neutral Start position.
Loren
 

[Robsolhayground]

. Kinda figured. Thanks