Yesterday's Tractor Co.
Shop Now View Cart
   Allis Chalmers Case Farmall IH Ford 9N,2N,8N Ford
   Ferguson John Deere Massey Ferguson Minn. Moline Oliver
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   Traditional YT Forum ViewClassic View   RegisterRegister 
 ProfileProfile    Log inLog in 

C Allis Mount and Dismount


 
Post new topic    
View previous topic :: View next topic  
Author Message
ric44
New User


Joined: 01 May 2011
Posts: 14


Report to Moderator

PostPosted: Mon Jan 21, 2019 8:31 am    Post subject: C Allis Mount and Dismount Reply to specific post Reply with quote

Guys I'm sure this topic has been discussed before but I'm looking for suggestions on how best to get down from the seat and back on the ground from one of these tractors ? I'm a rather large fellow and not so young as I used to be (64yo) . It has a step on the left side that makes getting on not too bad but I've yet to figure out the easiest way to get off . I know I could take the seat back off and slide off from behind but I'd like to leave it in factory configuration if possible . Give me some ideas and let me know how you big old guys do it lol . Just traded for this thing and love it but damn........
 
Back to top
View user's profile
john from Ontario
Regular


Joined: 26 Jan 2004
Posts: 49


Report to Moderator

PostPosted: Mon Jan 21, 2019 9:07 am    Post subject: Re: C Allis Mount and Dismount Reply to specific post Reply with quote

I have a step like you describe, which helps getting on, but I find it easier to dismount by swinging my legs over the fender and slide down the back. I do have a pan seat I can put on if I am planning to be on and off a lot. Nothing is real easy.
Funny, I never used to think there was any problem!
 
Back to top
View user's profile
Aaron SEIA
Tractor Expert


Joined: 16 Dec 2003
Posts: 2145
Location: SE Iowa

Report to Moderator

PostPosted: Mon Jan 21, 2019 10:11 am    Post subject: Re: C Allis Mount and Dismount Reply to specific post Reply with quote

I'm just spry enough I can still throw my right leg over the steering wheel and go off front wards. Try getting off with the front mount cultivator on...
AaronSEIA
 
Back to top
View user's profile
Traditional Farmer
Tractor Guru


Joined: 26 Apr 2007
Posts: 16589


Report to Moderator

PostPosted: Mon Jan 21, 2019 11:26 am    Post subject: Re: C Allis Mount and Dismount Reply to specific post Reply with quote

I figure that is why B and C tractors are cheap young guys don't want them and us old guys can't get on and off them.
 
Back to top
View user's profile
Brian G. NY
Long Time User


Joined: 02 Dec 2007
Posts: 893
Location: Upstate New York

Report to Moderator

PostPosted: Mon Jan 21, 2019 1:20 pm    Post subject: Re: C Allis Mount and Dismount Reply to specific post Reply with quote

My Dad left the plow drawbar on most of the time.
Makes a good step from either side.
Of course when the cultivators or mowing machine were mounted,
they provided their own steps of sorts.
 
Back to top
View user's profile
Dick L
Tractor Guru


Joined: 01 Sep 1999
Posts: 13262
Location: Edon Ohio

Report to Moderator

PostPosted: Mon Jan 21, 2019 2:45 pm    Post subject: Re: C Allis Mount and Dismount Reply to specific post Reply with quote

At 80 with bad legs I took the right fender off. I back up to the right side tire, place heel on the drawbar and work my rear up the tire until I am setting half on the tire and seat. I then slide my rear across the seat to where I can get my left foot on the left side of the steering wheel. Then I slide my rear back to the center of the seat ready to go.
 
Back to top
View user's profile
ric44
New User


Joined: 01 May 2011
Posts: 14


Report to Moderator

PostPosted: Mon Jan 21, 2019 3:29 pm    Post subject: Re: C Allis Mount and Dismount Reply to specific post Reply with quote

The weather is supposed to moderate a bit here in West Ky the next day or two so gonna practice the dismount . I'll get it figured out eventually maybe . I love putting around on this thing and would like to keep it around . Thanks for the tips .



 
Back to top
View user's profile
Butch(OH)
Tractor Expert


Joined: 19 Jun 2000
Posts: 3391


Report to Moderator

PostPosted: Tue Jan 22, 2019 4:05 am    Post subject: Re: C Allis Mount and Dismount Reply to specific post Reply with quote

In my opinion the best B-C mount and dismount fix is to get rid of the OEM seat and find a Monroe pan
seat. I am getting up there in age myself and it is easy to step on the draw bar with my left foot,
swing my right leg up past the seat to the right axle housing, then bring my left leg up and sit down. I would add that if a person is physically challenged there is no fix, I know of many that were sold when the owners could no longer mount them even with an aftermarket step or monroe seat.
 
Back to top
View user's profile
switch
Regular


Joined: 25 Jan 2017
Posts: 41


Report to Moderator

PostPosted: Sat Jan 26, 2019 7:13 am    Post subject: Re: C Allis Mount and Dismount Reply to specific post Reply with quote

Make a real double step. Mount between axle
and that first bolt for cultivator at a45
degree angle. Easier than it sounds.
 
Back to top
View user's profile
1954Frank
Regular


Joined: 08 Sep 2018
Posts: 115


Report to Moderator

PostPosted: Mon Jan 28, 2019 11:42 am    Post subject: Re: C Allis Mount and Dismount Reply to specific post Reply with quote

Nice looking C. I'm jealous! Wish I had another one.
 
Back to top
View user's profile
:   
Post new topic    Yesterday's Tractors Forum Index -> Allis Chalmers All times are GMT - 8 Hours
Page 1 of 1

 
Jump to:  

TRACTOR PARTS TRACTOR MANUALS
Fast Shipping!  Most of our stocked parts ship within 24 hours (M-Th). We have the parts you need to repair your tractor - the right parts. Our fast shipping, low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]

YT Home  |  Forums

Modern View Forum powered by phpBB © 2001, 2005 phpBB Group

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters