Yesterday's Tractor Co.
Shop Now View Cart
   Allis Chalmers Case Farmall IH Ford 9N,2N,8N Ford
   Ferguson John Deere Massey Ferguson Minn. Moline Oliver
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   Traditional YT Forum ViewClassic View   RegisterRegister 
 ProfileProfile    Log inLog in 

UTS Waterpump Question


 
Post new topic    
View previous topic :: View next topic  
Author Message
prairieplow07
Regular


Joined: 04 Oct 2008
Posts: 102


Report to Moderator

PostPosted: Wed Mar 20, 2019 5:12 pm    Post subject: UTS Waterpump Question Reply to specific post Reply with quote

Is this too far gone for a good seal? I read where the surface could be turned. If so, how much.

Thanks.



 
Back to top
View user's profile
Charlie Biler x
Regular


Joined: 26 Apr 2009
Posts: 116


Report to Moderator

PostPosted: Wed Mar 20, 2019 5:56 pm    Post subject: Re: UTS Waterpump Question Reply to specific post Reply with quote

Sir,
You are not showing the seal face. That is the important machined surface. The surfaces you are showing really are just along for the ride. Generally you just need to take off ten thousandths to get the surface back. I have turned off up to fifty thou with no problem. The #KE534A seal has a lot of spring action and can push a lot more than it has to. I personally turn until there are no felt radial marks left. Concentric marks do not count on pump seals.
If you are going to turn the #KE524A housing; I suggest you use a M2 bit using positive rake and keep the surface at 80 microinch finish. I personally turn to a 40 microinch finish. Just make sure to never leave any lubricants that will ruin the pump seal face.
If the pressed in #KE525 bronze bearing is wobbly; I would replace that while it was in the lathe. Just remember to not use brass or bearing bronze when changing the bearing. The original Oilite material bearing is what should be used.
Take care.
Charlie
 
Back to top
View user's profile
:   
Post new topic    Yesterday's Tractors Forum Index -> Minneapolis Moline All times are GMT - 8 Hours
Page 1 of 1

 
Jump to:  

TRACTOR PARTS TRACTOR MANUALS
Fast Shipping!  Most of our stocked parts ship within 24 hours (M-Th). We have the parts you need to repair your tractor - the right parts. Our fast shipping, low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]

YT Home  |  Forums

Modern View Forum powered by phpBB © 2001, 2005 phpBB Group

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters