Yesterday's Tractor Co.
Shop Now View Cart
   Allis Chalmers Case Farmall IH Ford 9N,2N,8N Ford
   Ferguson John Deere Massey Ferguson Minn. Moline Oliver
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   Traditional YT Forum ViewClassic View   RegisterRegister 
 ProfileProfile    Log inLog in 

NAA 3 Point Hydraulics


 
Post new topic    
View previous topic :: View next topic  
Author Message
flipndi
New User


Joined: 18 Apr 2019
Posts: 1


Report to Moderator

PostPosted: Thu Apr 18, 2019 11:51 am    Post subject: NAA 3 Point Hydraulics Reply to specific post Reply with quote

I have Julbilee that has been giving me problems with the 3 point hydraulics. It worked fairly well when we got it 2 years ago, but it has been giving me a hard time lifting and has now decided to not lift at all.

With the tractor being newer to me and not in the best shape I thought it would be good to go over the entire system.

Started with the pump on the motor. Got it off, apart and rebuilt and back together. That was fairly simple.

Then took off top cover to put in new piston and ring. While examining the control lift cylinder I found the control valve (part NAA913) was sticking rather badly. I was able to remove and found some small nicks on the valve that are probably the cause of it sticking. It also has a broken shaft where the pin connects to adjusting screw. So with the broken connector it seems we need to replace that part. Finding the part seems to be the challenge. Also in reading about repairing this may be more than I bargained for.

So is there anywhere we can get the parts to fix this? Or maybe a place the Lift Cylinder can be sent for rebuilding? I would like to get it repaired properly so it will work as intended.

Any suggestions from the experts on this forum to help get it going?
 
Back to top
View user's profile
:   
Post new topic    Yesterday's Tractors Forum Index -> Ford 9N, 2N, 8N All times are GMT - 8 Hours
Page 1 of 1

 
Jump to:  

TRACTOR PARTS TRACTOR MANUALS
Fast Shipping!  Most of our stocked parts ship within 24 hours (M-Th). We have the parts you need to repair your tractor - the right parts. Our fast shipping, low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]

YT Home  |  Forums

Modern View Forum powered by phpBB © 2001, 2005 phpBB Group

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters