Yesterday's Tractor Co.
Shop Now View Cart
   Allis Chalmers Case Farmall IH Ford 9N,2N,8N Ford
   Ferguson John Deere Massey Ferguson Minn. Moline Oliver
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   Traditional YT Forum ViewClassic View   RegisterRegister 
 ProfileProfile    Log inLog in 

IXB-3 Water in the Oil


 
Post new topic    
View previous topic :: View next topic  
Author Message
KV Bruce
Regular


Joined: 14 Dec 2011
Posts: 168
Location: Kern Valley, California

Report to Moderator

PostPosted: Mon Jun 03, 2019 6:40 am    Post subject: IXB-3 Water in the Oil Reply to specific post Reply with quote

I have a 1947 IXB-3 engine in my BF Avery model A. I am getting water in the oil and it doesn't take long to get there. Five minutes after a new head gasket. I do not get any oil in the coolant. I did use sealer on the head bolts and torqued to 35 ft lbs. I then drained the oil and coolant, put 4 qts of new oil and ran the engine squirting water into the water jacket opening on the lower left side. Not wanting to overheat it, I only ran if for a few minutes. No water in the oil after this. I was thinking that the water jacket my be cracked, but I'm not convinced now. I do have another head off a later model Hercules that had a water pump but the head has a considerable smaller combustion chamber. (higher compression for sure) I would like to try the different head but fear the higher compression might need a better cooling system. Any thoughts or experience with this little engine would be appreciated. I overhauled it last year and only drove it in a couple of parades. Bruce
 
Back to top
View user's profile
J. Schwiebert
Tractor Guru


Joined: 27 Sep 2013
Posts: 4460


Report to Moderator

PostPosted: Mon Jun 03, 2019 8:28 am    Post subject: Re: IXB-3 Water in the Oil Reply to specific post Reply with quote

Send me an e-mail and your phone number. Thanks! J.
 
Back to top
View user's profile
:   
Post new topic    Yesterday's Tractors Forum Index -> Minneapolis Moline All times are GMT - 8 Hours
Page 1 of 1

 
Jump to:  

TRACTOR PARTS TRACTOR MANUALS
Fast Shipping!  Most of our stocked parts ship within 24 hours (M-Th). We have the parts you need to repair your tractor - the right parts. Our fast shipping, low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]

YT Home  |  Forums

Modern View Forum powered by phpBB © 2001, 2005 phpBB Group

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters