Yesterday's Tractor Co.
Shop Now View Cart
   Allis Chalmers Case Farmall IH Ford 9N,2N,8N Ford
   Ferguson John Deere Massey Ferguson Minn. Moline Oliver
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   Traditional YT Forum ViewClassic View   RegisterRegister 
 ProfileProfile    Log inLog in 

Case 401 fuel pump question


 
Post new topic    
View previous topic :: View next topic  
Author Message
Josh Hagan
Regular


Joined: 28 Oct 2015
Posts: 42


Report to Moderator

PostPosted: Mon Jul 15, 2019 9:42 am    Post subject: Case 401 fuel pump question Reply to specific post Reply with quote

My brothers 400 sat a few days. When he went to start it it wasn?t getting fuel. Took the governor cover off and pushed the governor linkage ahead and will run. But slowly throttles down and will not respond when movin throttle linkage. Seems like something is broken between where the throttle spline shaft goes into the pump and where I can push on governor. Any thoughts?
 
Back to top
View user's profile
jon f mn
Tractor Guru


Joined: 25 Jan 2012
Posts: 14353
Location: Pine City Mn

Report to Moderator

PostPosted: Mon Jul 15, 2019 11:17 am    Post subject: Re: Case 401 fuel pump question Reply to specific post Reply with quote

You sure it's not just sticking? They are known to stick and need to be freed up. Try working it back as forth a bit to see if it loosens. If you take it apart watch for tiny parts to fall out, and it will have pressure behind it do it may pop out at you.
 
Back to top
View user's profile AIM Address
oldproudvet
Long Time User


Joined: 05 Sep 2010
Posts: 1445


Report to Moderator

PostPosted: Mon Jul 15, 2019 11:53 am    Post subject: Re: Case 401 fuel pump question Reply to specific post Reply with quote

I've 2 400s and both have been known to stick over the years, if they sit to long. I've just sprayed carb cleaner to free things up.......
 
Back to top
View user's profile
Josh Hagan
Regular


Joined: 28 Oct 2015
Posts: 42


Report to Moderator

PostPosted: Mon Jul 15, 2019 12:34 pm    Post subject: Re: Case 401 fuel pump question Reply to specific post Reply with quote

Will try thanks guys
 
Back to top
View user's profile
:   
Post new topic    Yesterday's Tractors Forum Index -> Case and David Brown All times are GMT - 8 Hours
Page 1 of 1

 
Jump to:  

TRACTOR PARTS TRACTOR MANUALS
We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]

YT Home  |  Forums

Modern View Forum powered by phpBB © 2001, 2005 phpBB Group

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters