Yesterday's Tractor Co.
Shop Now View Cart
   Allis Chalmers Case Farmall IH Ford 9N,2N,8N Ford
   Ferguson John Deere Massey Ferguson Minn. Moline Oliver
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   Traditional YT Forum ViewClassic View   RegisterRegister 
 ProfileProfile    Log inLog in 

530 PTO seal replacement.


 
Post new topic    
View previous topic :: View next topic  
Author Message
KJohnson92
Regular


Joined: 24 May 2019
Posts: 91


Report to Moderator

PostPosted: Tue Aug 13, 2019 3:00 pm    Post subject: 530 PTO seal replacement. Reply to specific post Reply with quote

Well, today I hooked the old ih 1300
sickle mower to the 530 to cut some
ditches. As usual I checked the pto fluid
before using the pto, and to my dismay
was greeted with the smell of
the new gear oil I put in the gearbox a
couple weeks ago. I know this is a common
problem, and have found the needed seal,
but I'm just wondering how much of a job
it is to get to the darn thing. Do I just
have to remove the cover or does the
whole rear end gotta come off? On an
unrelated note it also seems the fresh
gear oil found a place to leak out around
the right side brake. Just a gasket there
i hope? Any special tools I need besides
a complete set of ratchets and sockets
and prybars?
 
Back to top
View user's profile
Mike M
Tractor Guru


Joined: 31 Mar 1998
Posts: 28577


Report to Moderator

PostPosted: Wed Aug 14, 2019 4:12 am    Post subject: Re: 530 PTO seal replacement. Reply to specific post Reply with quote

The whole rockshaft housing has to come off to access that seal.
 
Back to top
View user's profile
KJohnson92
Regular


Joined: 24 May 2019
Posts: 91


Report to Moderator

PostPosted: Wed Aug 14, 2019 5:48 am    Post subject: Re: 530 PTO seal replacement. Reply to specific post Reply with quote

Oh boy. Guess I'm in for some fun ha. Probably best bet is chain it to a loader I would guess?
 
Back to top
View user's profile
Mike M
Tractor Guru


Joined: 31 Mar 1998
Posts: 28577


Report to Moderator

PostPosted: Wed Aug 14, 2019 6:17 am    Post subject: Re: 530 PTO seal replacement. Reply to specific post Reply with quote

Yes some way to lift it will be needed. Too heavy for hand lifting.
 
Back to top
View user's profile
:   
Post new topic    Yesterday's Tractors Forum Index -> John Deere All times are GMT - 8 Hours
Page 1 of 1

 
Jump to:  

TRACTOR PARTS TRACTOR MANUALS
Fast Shipping!  Most of our stocked parts ship within 24 hours (M-Th). We have the parts you need to repair your tractor - the right parts. Our fast shipping, low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]

YT Home  |  Forums

Modern View Forum powered by phpBB © 2001, 2005 phpBB Group

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters