Yesterday's Tractor Co.
Shop Now View Cart
   Allis Chalmers Case Farmall IH Ford 9N,2N,8N Ford
   Ferguson John Deere Massey Ferguson Minn. Moline Oliver
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   Traditional YT Forum ViewClassic View   RegisterRegister 
 ProfileProfile    Log inLog in 

Terratrac G556


 
Post new topic    
View previous topic :: View next topic  
Author Message
Northrop
New User


Joined: 30 Nov 2019
Posts: 1


Report to Moderator

PostPosted: Sat Nov 30, 2019 7:37 pm    Post subject: Terratrac G556 Reply to specific post Reply with quote

How do you adjust/tighten the track on a terratrac G556?
 
Back to top
View user's profile
Jim.ME
Tractor Expert


Joined: 02 Mar 2018
Posts: 1555


Report to Moderator

PostPosted: Sun Dec 01, 2019 3:10 pm    Post subject: Re: Terratrac G556 Reply to specific post Reply with quote


Do you see a sleeve with a square or hex on it attached to the idler yoke, it may have a jam nut next to it. You adjust it there by turning the sleeve to push the idler forward, which tightens the track. I think that is the arrangement you will see.
 
Back to top
View user's profile
TGP
Long Time User


Joined: 05 Mar 2009
Posts: 533
Location: So. IL.

Report to Moderator

PostPosted: Mon Dec 02, 2019 4:19 pm    Post subject: Re: Terratrac G556 Reply to specific post Reply with quote

As Jim said turn the Large nut behind the idler yoke.

You will have to cut out a wrench from thick plate (1/2")
Weld your new wrench offset to a 4' piece of pipe.

You won't get very far using a pipe wrench.
One you can't get in there well
and
Two after you round off the flats your done.

Tom
 
Back to top
View user's profile
:   
Post new topic    Yesterday's Tractors Forum Index -> Crawlers, Dozers, Loaders and Backhoes All times are GMT - 8 Hours
Page 1 of 1

 
Jump to:  

TRACTOR PARTS TRACTOR MANUALS
Fast Shipping!  Most of our stocked parts ship within 24 hours (M-Th). We have the parts you need to repair your tractor - the right parts. Our fast shipping, low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]

YT Home  |  Forums

Modern View Forum powered by phpBB © 2001, 2005 phpBB Group

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters