Yesterday's Tractor Co.
Shop Now View Cart
   Allis Chalmers Case Farmall IH Ford 9N,2N,8N Ford
   Ferguson John Deere Massey Ferguson Minn. Moline Oliver
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   Traditional YT Forum ViewClassic View   RegisterRegister 
 ProfileProfile    Log inLog in 

John Deere 318 Needs Choke Out To Run


 
Post new topic    
View previous topic :: View next topic  
Author Message
CaseChev
Regular


Joined: 12 Jan 2008
Posts: 299


Report to Moderator

PostPosted: Sat Oct 17, 2020 10:22 am    Post subject: John Deere 318 Needs Choke Out To Run Reply to specific post Reply with quote

Late model John Deere 318. My brother was mowing and started to run poorly.....pulled choke out and seemed to help in order to finish. Then started to run like too much fuel......pushed choke in and ran OK for awhile. This scenario was repeated several times. What would be some high probability things to look at or diagnose ? Thanks
 
Back to top
View user's profile
wore out
Long Time User


Joined: 01 Oct 2019
Posts: 1106


Report to Moderator

PostPosted: Sat Oct 17, 2020 11:01 am    Post subject: Re: John Deere 318 Needs Choke Out To Run Reply to specific post Reply with quote

The carburetor needs to be cleaned, a COMMON issue with the Onans, and it's a miserable job to remove the carburetor to clean t thoroughly due to all the shrouding on the engine.

Also, the intake manifold is made in two pieces and sealed together with silicone (DUMB) and they can fail over time and leak air into the fuel mixture causing a lean condition.

But from your description, the problem comes and goes, pointing to a carb issue.
 
Back to top
View user's profile
gab
Tractor Guru


Joined: 19 Jun 2003
Posts: 5210


Report to Moderator

PostPosted: Sat Oct 17, 2020 12:21 pm    Post subject: Re: John Deere 318 Needs Choke Out To Run Reply to specific post Reply with quote

I have two Onans in Wheel Horse tractors, Usually at least one of them a year will start surging really bad. I think it's from a plugged air bleed in the top of the carb. I take the air filter out and the plastic piece over carb. throat and spray carb. cleaner around the top inside of the carb, let it set awhile then blow that area out with air, keep a rag kinda covering it so you don't get a face full of gas.

You still could have some crap inside but I've had good luck with the carb. cleaner and air for a bad surging problem.
 
Back to top
View user's profile
:   
Post new topic    Yesterday's Tractors Forum Index -> Garden Tractors All times are GMT - 8 Hours
Page 1 of 1

 
Jump to:  

TRACTOR PARTS TRACTOR MANUALS
We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]

YT Home  |  Forums

Modern View Forum powered by phpBB © 2001, 2005 phpBB Group

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters