Yesterday's Tractor Co.
Shop Now View Cart
   Allis Chalmers Case Farmall IH Ford 9N,2N,8N Ford
   Ferguson John Deere Massey Ferguson Minn. Moline Oliver
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   Traditional YT Forum ViewClassic View   RegisterRegister 
 ProfileProfile    Log inLog in 

Oliver 55 injectors removal


 
Post new topic    
View previous topic :: View next topic  
Author Message
Blue Crew
New User


Joined: 10 Feb 2019
Posts: 15


Report to Moderator

PostPosted: Sat Oct 17, 2020 12:44 pm    Post subject: Oliver 55 injectors removal Reply to specific post Reply with quote

Got the Ollie 55 diesel home out of the weeds and brush that grew up around it. The engine is seized. Was going to fill the cylinders with transmission fluid and acetone. Removed fuel lines and injector stud bolts. Manual says "carefully remove injectors from cylinder head". Injectors aren't budging.

On the opposite side of the block are 4 cap screws. Do these cover the end of the injectors? Can I tap the injectors out from the opposite side? Any suggestions appreciated.
 
Back to top
View user's profile
J.Wondergem
Tractor Guru


Joined: 05 Mar 2009
Posts: 5847


Report to Moderator

PostPosted: Sat Oct 17, 2020 1:47 pm    Post subject: Re: Oliver 55 injectors removal Reply to specific post Reply with quote


Nope, you can't do that. I used a crows foot bar to get mine out. Put some pressure on it and taped it with a hammer.
 
Back to top
View user's profile
J.Wondergem
Tractor Guru


Joined: 05 Mar 2009
Posts: 5847


Report to Moderator

PostPosted: Sat Oct 17, 2020 3:08 pm    Post subject: Re: Oliver 55 injectors removal Reply to specific post Reply with quote


forgot to say i did it on a 88.
 
Back to top
View user's profile
super99
Tractor Guru


Joined: 19 Jan 2002
Posts: 4485
Location: Rock Island county, Ill

Report to Moderator

PostPosted: Sat Oct 17, 2020 4:52 pm    Post subject: Re: Oliver 55 injectors removal Reply to specific post Reply with quote

Don't try to turn the engine until you know that the expensive, hard to get little shaft in the injection pump is free!!!!
 
Back to top
View user's profile
Blue Crew
New User


Joined: 10 Feb 2019
Posts: 15


Report to Moderator

PostPosted: Mon Oct 19, 2020 3:17 pm    Post subject: Re: Oliver 55 injectors removal Reply to specific post Reply with quote

Which shift? How do I check it? How do I free it if it is seized?
 
Back to top
View user's profile
:   
Post new topic    Yesterday's Tractors Forum Index -> Oliver, Cletrac, Coop and Cockshutt All times are GMT - 8 Hours
Page 1 of 1

 
Jump to:  

TRACTOR PARTS TRACTOR MANUALS
We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]

YT Home  |  Forums

Modern View Forum powered by phpBB © 2001, 2005 phpBB Group

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters